Datasheet
80.01 80.11
1 CO (SPDT) 1 CO (SPDT)
16/30 16/30
250/400 250/400
4,000 4,000
750 750
0.55 0.55
16/0.3/0.12 16/0.3/0.12
500 (10/5) 500 (10/5)
AgCdO AgCdO
12…240 24...240
12…240 24...240
< 1.8 / < 1 < 1.8 / < 1
(10.8...265)V (17...265)V
(10.8...265)V (17...265)V
(0.1…2)s, (1…20)s, (0.1…2)min, (1…20)min, (0.1…2)h, (1…24)h
± 1 ± 1
≤ 50 ≤ 50
50 —
± 5 ± 5
100·10
3
100·10
3
–10…+50 –10…+50
IP 20 IP 20
Wiring diagram
(without signal START)
• Multi-voltage
• Mono-function
• Multi-voltage
• Multi-function
AI: ON delay
DI: ON pulse
SW: Symmetrical recycling: ON start
BE: Signal OFF delay
CE: Signal ON and OFF delay
DE: Signal ON pulse
AI: ON delay
Wiring diagram
(with signal START)
Wiring diagram
(without signal START)
Contact specification
Contact configuration
Rated current/Maximum peak current A
Rated voltage/Maximum switching voltage V AC
Rated load AC1 VA
Rated load AC15 (230 V AC) VA
Single phase motor rating (230 V AC) kW
Breaking capacity DC1: 30/110/220 V A
Minimum switching load mW (V/mA)
Standard contact material
Supply specification
Nominal voltage (U
N
) V AC (50/60 Hz)
V DC
Rated power AC/DC VA (50 Hz)/W
Operating range AC
DC
Technical data
Specified time range
Repeatability %
Recovery time ms
Minimum control impulse ms
Setting accuracy-full range %
Electrical life at rated load in AC1 cycles
Ambient temperature range °C
Protection category
Approvals (according to type)
1
Features
Multi-function and mono-function timer range
80.01 - Multi-function & multi-voltage
80.11 - ON delay, multi-voltage
• 17.5 mm wide
• Six time scales from 0.1s to 24h
• High input/output isolation
• 35 mm rail (EN 60715) mount
• “Blade + cross” - both flat blade and cross head
screw drivers can be used to adjust the range
and function selectors, the timing trimmer, and
to disengage the rail mounting clip
• New multi-voltage versions with “PWM clever”
technology
80.01
80.11
80.01 / 80.11
Screw terminal
FOR UL HORSEPOWER AND PILOT DUTY RATINGS
SEE “General technical information” page V
80 Series - Modular timers 16 A