Datasheet

ZDPENXXRE84 - II/16 - Printed in Italy
84 SERIES
SMARTimer - Digital timer with NFC programming
FINDER reserves the right to alter characteristics at any time without notice.FINDER assumes no liability for damage to persons or property, caused as a result of the incorrect use or application of its products.
Type 84.02.0.230.0000
- Nominal voltage:
110…240 V AC/DC (non-polarized)
- Operating range:
90…264 V AC/DC (47/63Hz)
Type 84.02.0.024.0000
- Nominal voltage:
12…24 V AC/DC (non-polarized)
- Operating range:
10…30 V AC/DC (47/63Hz)
- It’s possible to directly connect
timer input to proximity sensors
(both PNP and NPN)
• Two independent Start input -
one per channel
• One common Reset input
(select to apply to either, or both, channels)
• One common Pause input
(select to apply to either, or both, channels)
• PIN to protect access
to programming session
• Up or Down timing modes
• Setting accuracy-full range: ± 0,05%
• Ambient temperature range: -20° + 50°
• 35 mm rail (EN 60715) mount
18 16 15 28 26 25
OFF Relay OFF
ON Relay ON
AI On-delay
DI Interval
GI Pulse delayed
LI Asymmetrical asher (starting pulse ON)
PI Asymmetrical asher (starting pulse OFF)
SW Asymmetrical asher (starting pulse ON)
SP Asymmetrical asher (starting pulse OFF)
AE On-delay with control signal
BE O-delay with control signal
CE On- and o-delay with control signal
DE Interval with control signal ON
EE Interval with control signal OFF
FE Interval with control signal ON and OFF
EEa Interval with control signal OFF (retriggerable)
EEb Interval with control signal OFF
WD Watchdog (retriggerable interval with control signal ON)
GE Pulse delayed with control signal ON
LE Asymmetrical asher (starting pulse ON) with control signal
PE Asymmetrical asher (starting pulse OFF) with control signal
IT Timing step
SS Monostable controlled by Signal switch
PS Monostable controlled by Pause switch
SHp Shower function (o-delay with control signal and pause signal)
FUNCTIONS
findernet.com