Datasheet

H
Multi-function SMARTimer
Type 84.02
- 1 CO (16A) + 1 CO (16A)
• 2 in 1: two independent channels
• Two supply version available: 12…24VAC/DC
and 110…240VAC/DC (not polarized)
• Two programming modes: “Smart” mode via
smartphone with NFC communication or
“Classic” mode via the joystick
• Wide backlit display for easy reading all
information during the programming phase
and during normal operation
• Flexibility: possible to create new specific
functions, mixing the 25 available functions on
each channel
• High precision and possibility of choice in time
set-up:
- Time units; 0.1 seconds, seconds, minutes,
hours
- Set-time to 4 digits, anywhere between
000.1 second and 9999 hours
• Large display allows easy viewing: set time,
current time, timing in progress, input
command state, output state
• Two independent Start inputs - one per
channel
• One common Reset input (select to apply to
either, or both, channels)
• One common Pause input (select to apply to
either, or both, channels)
• PIN to protect access to programming session
• Up or Down timing modes
• Type 84.02.0.024.0000: it's possible to directly
connect timer input to proximity sensors (both
PNP and NPN)
• 35mm rail (EN60715) mount
Screw terminal
84.02
• 2 CO 16A output contacts
• Digital Timer “Two in one”: two totally
independent programmable channels, in a
single product
18 16 15
28 26 25
Wiring diagram
For outline drawing see page 3
Contact specification
Contact configuration 2 CO (DPDT)
Rated current/Maximum peak current A 16/30
Rated voltage/
Maximum switching voltage VAC 250/400
Rated load AC1 VA 4000
Rated load AC15 (230VAC) VA 1000
Single phase motor rating (230VAC) kW 0.55
Breaking capacity DC1: 30/110/220 V A 16/0.3/0.12
Minimum switching load mW (V/mA) 300 (5/5)
Standard contact material AgNi
Supply specification
Nominal voltage (U
N
) VDC/AC (50/60Hz) 12…24 110…240
Rated power AC/DC VA (50Hz)/W 2.2/1.2 4/1.6
Operating range VDC/AC 10…30 90…264
Technical data
Specified time range 0.1s…9999h
Repeatability % ±0.05
Recovery time ms 40*
Minimum control impulse ms 40
Setting accuracy % ±0.05
Electrical life at rated load in AC1 cycles 100·10
3
Ambient temperature range °C –20…+50
Protection category IP 20
Approvals (according to type)
* Applies where timer function is controlled by an input to B terminal(s). Where power-off is used to reset the timer,
the recovery time can increase up to 500 ms, depending on supply voltage.
2
in
1
1
VI-2016, www.findernet.com
84
SERIES
84 SERIES
SMARTimer 16A