User's Manual

Receiver Model : WH2802
Sensor Model : WH32G
Version 1.0 Page 13
Command
Function
Description
Settings
ALARM +
2 seconds
Alarm
Hour
Set the Alarm Hour Time
Press TEMP/+ or BARO/- to
increase or decrease the alarm hour.
SET
Alarm
Minute
Set the Alarm Hour Minute
Press TEMP/+ or BARO/- to
increase or decrease the alarm
minute.
SET
ALARM
ON/OFF
Turn the Time Alarm On or
Off.
Press TEMP/+ to toggle between
Time Alarm ON and Time Alarm Off
SET
LOW
Alarm
Turn the LOW Temperature
Alarm On or Off
Press TEMP/+ to toggle between
Time Alarm ON and Time Alarm Off
SET
Exit Set Mode
Figure 10
4.4.3 Cancelling the Alarm
If the time alarm sounds, press the any key to silence the alarm. Press the LIGHT/SNOOZE key
to enter snooze mode.
The low temperature alert will reset automatically once the value has fallen into the low
temperature alert range.
4.4.4 Low Temperature Alarm
The low temperature alarm sounds when the outdoor is between -3 °C and +2 °C (26.6 °F and
35.6 °F). The LO temperature icon will appear and flash on the console. If the BEEP is
switched on, an audible alert will also activated when the low temperature alert occurs.
Figure 11
4.5 Calibration
While in the normal node, press and hold the SET and BARO/- keys for five seconds to enter
calibration mode (note: the SET mode will appear after three seconds. Continue pressing the two
keys until you see the CAL icon appear in the upper right hand corner of the display).
Enter the calibration offset to match the calibration source.