User's Manual

Receiver Model : WH2802
Sensor Model : WH32G
Version 1.0 Page 9
you have metal siding, align the remote and console through a window to get a clear line of sight.
The following is a table of reception loss vs. the transmission medium. Each “wall” or obstruction
decreases the transmission range by the factor shown below.
Medium
RF Signal Strength Reduction
Glass (untreated)
5-15%
Plastics
10-15%
Wood
10-40%
Brick
10-40%
Concrete
40-80%
Metal
90-100%
4 Console Operation
Note: The console has four keys for easy operation: TEMP/+ key, ALARM key, BARO/-
key and SET key. There are four program modes: Set Mode, Alarm Mode, Calibration Mode and
Min/Max Mode.
Any program mode can be exited at any time by either pressing the SNOOZE/LIGHT key (on
the top of the display console), or waiting for the 30-second time-out to take effect.
4.1 Set Mode
The Set Mode allows you to change date, time, units of measure and other important functions, as
referenced in Figure 8.
To enter the Set Mode, press and hold the SET key for two seconds (SET + 2 seconds). To
advance each command, press (do not hold) the SET key.