Owner's manual

82
CONTENTS
Monitoring Terminal Activity
This is a special function to monitor door accessibilities. Unlike Terminal Data Audit List, this
page does not show previous clocking activities but it shows only the current clocking activi-
ties. The same concept applies to the Terminal Data Audit List, where user’s clocking data is
downloaded immediately to the software for viewing.
Synchronization of the date and time of the terminals can be done from this page. It can also
be used to open door(s) for users. You can upload photo of users into the software, and these
photos will be shown on the screen if user is verified at the connected terminal.
Step 1: Click to open Monitor Terminal Activity.
Step 2: Click “Online” to connect to all terminals. Click “Select Terminal ID” if you wish to se-
lect terminals for viewing. The same methods for the Terminal Data Audit List is applied here.
Step 3: During online status, all verified user IDs at the connected terminals will be down-
loaded into the software. The user ID and its verified time will be published on the screen. Click
“Open” button to request a particular terminal to open door and this application is invalid if you
are using AdapTec AC to control the door. Click “Sync” button to synchronize date and time of
the connected terminals to the computer’s time. You can click “Show Photo” and the software
will show the photo of the verified users. Click “Pause” if you want to stop the Online status.