Instruction Manual

Screwdriver

Use the screwdriver to open

the back plate of ngerprint

terminal and to install the

back plate against a wall.

A Packet of Bolts

Use the screws to hold the back

plate of the terminal against a wall.

RFID Cards (5 pieces)

For card enrollment and

verication.

TCP/IP Connector

Connect the network cable from

a PC or Network switch to a TCP/

IP connector at the terminal.

Door Accessories Cable

Cables for 12V door lock, push

button, 12V alarm, door sensor and

12V door bell, for door access.

RS232/RS485/Wiegand Output

Cable

For serial cable connection and

Wiegand output connection.

Power Connector

To connect the terminal to a

12V power supply.

Diode

A diode allows electricity to ow in

one direction only and blocks the

ow in the opposite direction. This

is known as a one-way valve on EM

Lock power for protection.

1• GETTING STARTED

Viewing the User Guide in the Internet

The User Guide is available in the package when you purchased the terminal. The User

Guide is also available online at:

http://www.fingertec.com & http://user.fingertec.com

Choose the language that you prefer for your User Guide.

Terminal Included Accessories

Do not abuse the fingerprint sensor by scratching the surface, contacting the sen-

sor’s surface with heat, pressing hard during placement of fingerprint for verifica-

tion. Clean the sensor occasionally with microfiber cloth to maintain the perform-

ance of the sensor.