Use and Care Manual

24
1)
Disconnect air hose from tool. Remove all nails from tool.
● ALL SCREWS MUST BE TIGHTENED. If any screws
are loose, tighten them.
● THE SAFETY AND TRIGGER MUST MOVE
SMOOTHLY.
2) Adjust the air pressure to 60PSI, connect the air hose.
Do not load any nails in the tool.
● THE TOOL MUST NOT LEAK AIR.
3) Remove the finger from the trigger and press the
safety (A - Fig. 24) against the wood.
● THE TOOL MUST NOT OPERATE.
4) Separate the safety from the wood. Next, point the
tool downward, pull the trigger and then wait in that
position for 5 seconds or longer.
● THE TOOL MUST NOT OPERATE.
5) - Without touching the trigger, depress the safety
against the workpiece. Pull the trigger.
● THE TOOL MUST OPERATE.
- Hold the trigger back while separating the safety
from the wood. The tool will remain in operated
status (the driver blade will remain at the bottom).
- Remove the finger from the trigger.
Tool operation will end (the driver blade will return
to the top).
6) If no abnormal operation is observed, you may load
nails in the tool. Drive nails into the workpiece that is
the same type to be used in the actual application.
● THE TOOL MUST OPERATE PROPERLY.
STAPLE LOADING
1) Connect the tool to the compressor as explained in the
Compressor manual at chapter “OPERATION - USING
THE AIR COMPRESSOR”.
2) Press the click lever (D) and pull the magazine (C) to
open position (Fig. 21).
3) See tool specification to determine appropriate nail
sizes. Insert appropriate nail strips (H), with the nail
tips contacting the wear rail (F) (Fig. 22).
4) Push the nail strip (H) against the nose.
5) Push magazine fully closed (Fig. 23). Click lever (D)
will maintain fully closed position.
REMOVING THE STAPLES
1) Disconnect air supply.
2) Press the click lever (D) and pull the magazine (C) to
open position (Fig. 21).
3) Grasp the head of the nail strip and remove it from the
magazine.
Fig. 21
Fig. 22
D
Fig. 23
H
F
C
WARNING:
Keep the tool pointed away from yourself and others
when loading fasteners. Failure to do could result in
possible serious personal injury.
Never load fasteners with the workpiece contact or
trigger activated. Doing so could result in possible
serious personal injury
C
WARNING:
When loading the tools magazine, check that the nail
tips contact the wear rail and slide smoothly against
the surface of the magazine. If the nails are not loaded
properly, the tool will misfire and nails can be deflected,
causing the tool to react in an unexpected manner, and
damage the tool.
MULTIPURPOSE STAPLER