Use and Care Manual
25
METHODS OF OPERATION
This tool is equipped with the safety (A) (Fig. 24) and does
not operate unless the safety is depressed.
The methods of operation to drive nails with this tool is
sequential actuation mechanism.
1) Position the nail outlet on the workpiece with finger off
the trigger (B).
2)
Depress the safety firmly until it is completely depressed.
3) Pull the trigger (B) (Fig. 24) to drive a nail.
4) Remove finger from the trigger.
To continue nailing a separate location, move the tool along
the wood, repeating steps (2-4) as required.
NOTE:
● Always handle nails and package carefully. If nails are
dropped, collating bent may be broken, which will cause
mis-feeding and jamming.
● After nailing:
1) Disconnect the air hose from the tool.
2) Remove all staples from the tool.
3) Supply 5-10 drops of pneumatic tool lubricant into
the air plug on the tool.
4) Open the drain valve on the air compressor tank to
drain any moisture.
ADJUSTING THE EXHAUST
The direction of the exhaust vent can be changed by turning
the top cover (Fig. 25).
MAINTENANCE
CLEARING A JAM FROM THE TOOL
If a nail remains jammed inside the nail gun, comply with
the following procedure:
1) Switch off the compressor.
2) Disconnect the stapler from the compressor.
3) Release the magazine (C) from the locked position,
pressing lever (D) (Fig. 21).
4) Slide the magazine (C) downwards (Fig. 21).
5) Using a suitable Allen wrench (G), remove screws (M)
- (N) and (O) located in the top part of the stapler (Fig.
26).
6) Remove cover (I) of the stapler (Fig. 27).
7) Remove the jammed nail.
8) Replace cover (I) of the stapler.
9) Using a suitable Allen wrench (G), refasten screws (M)
- (N) and (O) to cover (I).
10) Slide the magazine (C) upwards, pressing lever (D) at
the same time (Fig. 23).
11) Lock the magazine (C), releasing lever (D). Make sure
that the cartridge is firmly secured (Fig. 23).
12) Connect the stapler to the compressor as explained
in the Compressor manual at chapter “OPERATION -
USING THE AIR COMPRESSOR”.
13) Once the compressor has been restarted, the stapler
is ready for use again (Fig. 28).
B
A
MULTIPURPOSE STAPLER
D
G
N
O
I
A
B
M
Fig. 25
Fig. 26
Fig. 27
Fig. 28
Fig. 24