Surveyor User's Guide

11-27
Multi-QoS
Channel Table Details
11
Max Jitter (ms) Maximum Jitter in milliseconds. The value is calculated by Surveyor.
Surveyor uses the formula described in RFC 1889 to calculate jitter.
Low Seq Num Lowest Sequence Number. Lowest RTP sequence number seen.
High Seq Num Highest Sequence Number. Highest RTP sequence number seen.
RTCP Packet Count Real-time Transport Control Protocol (RTCP) Packet Count.
RTCP Byte Count RTCP Byte Count.
RTCP RTP Packet
Count
RTCP reported RTP Packet Count.
RTCP RTP Byte Count RTCP reported RTP Byte Count.
RTCP Jitter (ms) RTCP reported jitter. Average reported RTCP interarrival jitter.
RTCP Min Jitter (ms) RTCP reported minimum jitter. Minimum reported interarrival jitter.
RTCP Max Jitter (ms) RTCP reported maximum jitter. Maximum reported interarrival jitter.
RTCP High Seq Num High Sequence Number reported by RTCP.
RTCP Sender Report
Count
Number of RTCP Sender Reports seen.
RTCP Receiver Report
Count
Number of RTCP Receiver Reports seen.
RTCP Source Descrip-
tion Count
Number of RTCP Source Descriptions seen.
RTCP Goodbye Count Number of RTCP Goodbyes seen.
RTCP Application-
Defined Count
Number of RTCP Application Definitions seen.
RTCP Unknown Report
Count
Count of all other RTCP reports seen.
RTCP CName Canonical Name. (RTCP Source Description, CNAME field)
RTCP Name User’s Name. (RTCP Source Description, NAME field)
RTCP Email User’s electronic mail address. (RTCP Source Description, EMAIL
field)
RTCP Phone User’s phone number. (RTCP Source Description, PHONE field)
RTCP Location User’s geographic location. (RTCP Source Description, LOCATION
field)
RTCP Tool Name of application or tool. (RTCP Source Description, TOOL field)
RTCP Note Notice about the source. (RTCP Source Description, NOTE field)
Table 11-11. H.323, SIP, or UNKNOWN Channel Table Column Descriptions (continued)