Surveyor User's Guide

2-8
Surveyor
User’s Guide
5. To update the device driver, click with the right mouse on My Network Places.
Select
Properties from the menu.
6. Double-click on
Local Area Connection. The Racore device driver should
appear in the
Connect box.
7. Press
Configure and then select the Device Driver tab.
8. Press
Update Driver.... The Upgrade Device Driver Wizard displays. Click the
Next button to continue.
9. Select the
Display a list of the known device.... radio button and then click Next.
10. Click the
Have Disk... button. The Install from Disk window appears.
11. Insert the Surveyor CD in the CDROM drive.
12. Use the
Browse... button to find the Ethernet Driver (<CDROM-drive-
letter>\drivers) directory on the Surveyor CDROM and click OK.
13. The
Update Device Driver window will appear. Select the “Finisar 10/100
Ethernet Analyzer Plug_Play” driver. Click the
Next button.
14. Click the
Next button again when the next window appears. The system will
display the
Digital Signature Not Found dialog box. Click Yes. (Note: You can
safely ignore the warning message. The message appears because Windows
2000 does not recognize the card properly at this time.)
15. The Finisar driver will be copied to the hard drive. Windows 2000/XP may
request the Windows CDROM to install system files. Many of these system
files can be found directly on the hard drive in the
C:\windows\system and
C:\windows directory without using the CDROM.
16. To verify that the analyzer card is properly installed, open the
System folder in
the
Control Panel. Go to the Hardware tab in the System Properties window.
Select the
Device Manager. If no error marks exist through the Network icon, the
installation is complete. If an error exists, highlight the problem adapter and
press the
Remove button. Reboot the notebook computer and attempt the
installation again. If the problem persists, contact Technical Support.
17. Reboot your system.
Installing More Than One Analyzer Card in a Notebook PC
If you are installing two Portable Surveyor 10/100 Ethernet Analyzer Cards, install
one card, make sure it works within Surveyor, and then install the second card.