SDS

Special hazards in case of fire:
Hazardous Combustion Products: Carbon monoxide, Carbon dioxide, Toxic gases, Hydrogen cyanide, & Nitrogen containing gases.
Fire-Fighting Procedures:
Isolate immediate hazard area and keep unauthorized personnel out. Stop spill/release if it can be done safely. Move undamaged
containers from immediate hazard area if it can be done safely. Water spray may be useful in minimizing or dispersing vapors and to
protect personnel. Water may be ineffective but can be used to cool containers exposed to heat or flame. Caution should be exercised
when using water or foam as frothing may occur, especially if sprayed into containers of hot, burning liquid.
Dispose of fire debris and contaminated extinguishing water in accordance with official regulations.
Special Protective Actions:
Wear protective pressure self-contained breathing apparatus (SCBA) and full turnout gear.
SECTION 6) ACCIDENTAL RELEASE MEASURES
Emergency Procedure:
ELIMINATE all ignition sources (no smoking, flares, sparks or flames in immediate area).
Do not touch or walk through spilled material.
Isolate hazard area and keep unnecessary people away. Remove all possible sources of ignition in the surrounding area. Notify authorities
if any exposure to the general public or the environment occurs or is likely to occur.
If spilled material is cleaned up using a regulated solvent, the resulting waste mixture may be regulated.
Personal Precautions:
Avoid breathing vapor. Avoid contact with skin, eye or clothing. Do not touch damaged containers or spilled materials unless wearing
appropriate protective clothing.
Recommended Equipment:
Positive pressure, full-face piece self-contained breathing apparatus (SCBA), or positive pressure supplied air respirator with escape SCBA
(NIOSH approved).
Environmental Precautions:
Stop spill/release if it can be done safely. Prevent spilled material from entering sewers, storm drains, other unauthorized drainage systems
and natural waterways by using sand, earth, or other appropriate barriers.
Methods and Materials for Containment and Cleaning Up:
Cover spills with suitable inert absorbent like granulated clay and place in sealed chemical waste containers.
SECTION 7) HANDLING AND STORAGE
General:
Wash hands after use.
Do not get in eyes, on skin or on clothing.
Do not breathe vapors or mists.
Use good personal hygiene practices.
Eating, drinking and smoking in work areas is prohibited.
Remove contaminated clothing and protective equipment before entering eating areas.
Ventilation Requirements:
Use only with adequate ventilation to control air contaminants to their exposure limits. The use of local ventilation is recommended to
control emissions near the source.
Storage Room Requirements:
Keep container(s) tightly closed and properly labeled. Store in cool, dry, well-ventilated areas away from heat, direct sunlight, strong
oxidizers and any incompatibilities. Store in approved containers and protect against physical damage. Keep containers securely sealed
when not in use. Indoor storage should meet OSHA standards and appropriate fire codes. Containers that have been opened must be
carefully resealed to prevent leakage. Empty containers retain residue and may be dangerous. Use non-sparking ventilation systems,
approved explosion-proof equipment and intrinsically safe electrical systems in areas where this product is used and stored.
SECTION 8) EXPOSURE CONTROLS, PERSONAL PROTECTION
Eye Protection:
No special eye protection required under normal condition of use.
Skin Protection:
0653-XXXX-XXXX
Page 2 of 6
www.touchupsolutions.com