User's Manual

UM-0840 21

L N

TMB

4. If the Remote Unit has the NFPA Option, there is a dedicated cable gland for this purpose. A multi-

conductor cable can be used to connect the NFPA dry contacts to the Fire Department Control Box.

Figure 11; NFPA Dry Contact connection configuration

Figure 12; NFPA Dry Contact connection location inside the cabinet

5. Once the unit has been connected to the power source, it takes about 30 seconds to run a booting

routine. After that time unit is ready to be connected via USB cable to the Digital Master to a computer

running Fiplex Control Software (FCS) in order to be properly configured.

4 5 61 2 3

NC NO NC NO

Repeater

Fail

VSWR

Status of contacts (Alarms Off)

Pin 1 – 2 = VSWR (normally closed contact)

Pin 2 – 3 = VSWR (normally open contact)

Pin 4 – 5 = Repeater Fail (normally closed contact)

Pin 5 – 6 = Repeater Fail (normally open contact)