User's Manual

UM-0840 43
10. Once system is configured, user can disconnect software using connection button, now
labelled “Disconnect”. Initial window will be shown.
If repeater is disconnected or turned off, while Fiplex Control Software is connected to
device, software will go back to initial window. Moreover, if some communication problem
occurs while device is monitored, the software will go back to initial state as well.
11. Remote unit can be controlled through USB port. In this case, Fiplex Control Software will
show that connected device is a remote unit.
After click on “Connect” button, program will show only remote configuration and
monitoring parameters, with same graphical interface described in previous sections: