User guide

Distributed Audio Panel Manual — P/N 52265:B1 6/8/2010 25
Section 2: Field Programming
The ACC-25/50DA can be field programmed using option DIP switches S1 and S2 located in the
upper right side of the mother board. It is recommended that tone selection and background music
options be reviewed and approved by the local AHJ. Programming DIP switches are also located on
the ACC-ZPM Zone Page Module. DIP switches are also located on the optional Message Genera-
tor Module (FC-MGM). Refer to the following illustrations for details on DIP switch placement in
the ON and OFF positions.
!
CAUTION: STATIC SENSITIVE COMPONENTS
IN ORDER TO MINIMIZE RISK OF DAMAGE TO ANY CIRCUITS, DO NOT USE CONDUCTIVE
TOOLS WHEN CONFIGURING DIP SWITCHES.
Figure 2.1 Field Programming DIP Switches
ac25daswitc.wmf
Switches 1 through 7
shown in OFF position
Switch 8 shown
in ON position
S3 shown in Charger
Enabled position
Figure 2.2 Field Programming DIP Switch for ACC-ZPM
Switch 8 shown
in ON position
Switches 1 through 7
shown in OFF position
ACC-ZPM
EIA-485 Addressing Switches
Distributed Audio Panel Mother Board
ac25dazaswitc.wmf