User guide

Distributed Audio Panel Manual — P/N 52265:B1 6/8/2010 31
Switch SW1 Settings on Optional FC-MGM Module Field Programming
2.7 Switch SW1 Settings on Optional FC-MGM Module
SW1 - DIP Switch Settings
Custom messages can be recorded from four different audio sources:
PC microphone
PC line out
Microphone (P/N:FC-MICROPHONE)
RCA jack connected to an audio source
FC-MGM SW1 DIP switch settings are as follows:
Switch 1 - used to select an input for digital voice message recording:
ON = select alternate sources for message recording
OFF = select RCA Jack for message recording (factory default)
Switch 2 - used to configure the mini Audio Jack for digital voice message recording from
either a PC microphone or a PC audio output card:
ON = select PC line out for message recording
OFF = select PC microphone for message recording (factory default)
Switch 3 - used to enable recording of digital voice message:
OFF = disable recording of message (factory default)
ON = enable recording of message
Switch 4 - used to determine if a tone will be generated before the message is transmitted:
OFF = No tone before message
ON = Tone before message (factory default setting)
Switch 5 - used to determine if a tone will be generated after the message is generated:
OFF = No tone after message
ON = Tone after message (factory default setting)
Figure 2.5 Field Programming Switches on FC-MGM Module
Switch 1 set to ON
Switches 2 to 8 set to OFF
fc-mgm.wmf
fcmgmdip.wmf
NOTE: Only one of the four audio sources can be connected at one time.