Instruction Manual

Mounting Annunciators and Expanders 4. Installation
ACM-16ATF/ACM-32AF Manual PN 51480:A0 02/02/01
29
Mounting Annunciators and Expanders
Set the address Rotory Switches and DIP Switches as outlined in "Setting
Rotary and DIP Switches" on page 28 and the Appendix for specific fire
alarm control panels.
Install labels in annunciator module and expander module(s) as detailed in
"Installing Labels" on page 27.
Surface Mount Backbox (ABS Series)
1. Connect terminal blocks on circuit wiring in backbox to connectors on
annunciator.
2. Align the mounting holes on the annunciator with the threaded tabs on
the backbox and secure with the two screws provided. Tighten
securely.
Flush Mount Backbox (ABF Series)
ABF-1F Backbox Only.
1. Remove the backing from the gummed label and affix to the trim plate
as illustrated.
Note: If installing an Annunciator Key Switch (AKS-1F), use the label supplied with
the kit instead of the label that ships with the annunciator. Holes in label will align
with holes in trim plate.
Figure 9 Applying the Label
2. Place the trim plate face down, with the threaded studs facing up.
Position the annunciator over the threaded studs on the trim plate and
secure with the two nuts and lock washers provided. Tighten securely.
Figure 10 Assembling Trim Plate and Annunciator
ACSf-platelabel.cdr
ACSf-platemtg.cdr
Trim Plate
Annunciator
Nuts & Lockwashers
Studs