Owner's manual

Figure 9. IPDACT-2(UD) circuit details.
The device CPU, memory and the LAN (identifiable through the RJ-45
connector) are found in the control module. This manages all the information
procedure and the sending of the said information through an IP network over
the LAN.
The telephonic module physically supports the control and contains all the
connection points with the control panel. This manages the entire telephonic
interface with the control panel and the client telephone network (public
telephone network termination point and client phone wiring).
The IPDACT-2UD device has a V32 modem module that adds the necessary
elements to make telephonic data calls to the control panel and so support
upload/download functionality.
The IPDACT-2 device does not include the V.32 modem module.
From a configuration / monitoring point of view, the IPDACT-2(UD) possesses
LEDs that permit you to view the status of the various elements, from the P1
jumper to control various aspects and a telephonic/serial console. This
telephonic console is accessible from the connection to the control panel (TO-
AP) and requires an analog telephone with tone dialing.
The IPDACT-2(UD) has an asynchronous console which permits you to
monitor / configure the device through an asynchronous terminal.
IPDACT-2(UD) - Description
II-11
Doc.DM385-I
Rev. 4.0