Installation Instructions

REV 2 - 1103150807
L-C2-333
3
TABLE OF CONTENTS
PRODUCT DATA TABLE
Table 1 - Product Data Table
Note: The hanger requires 2"
(5.1 cm) of countertop
on each side and back to
support the unit.
Specifi cation Value
Counter opening height* 12" (30.5 cm)
Counter opening width* 19" (48.3 cm)
Counter opening depth* 18 3/4" (47.6 cm)
BTU 60,000 (17.6 kw)
Natural gas orifi ce left #30 (3.261mm)
Natural gas orifi ce right #46 (2.055 mm)
Propane gas orifi ce left #50 (1.778 mm)
Propane gas orifi ce right #1.25
*Note: If using an insulating liner
(part number 3278-50)
consult liner instructions for
counter cut-out dimensions.
ELECTRICAL SAFETY
To protect against electric shock, do not immerse cord or plugs (if equipped) in water or other liquid;
Unplug from the outlet (if applicable) when not in use and before cleaning. Allow to cool before putting on or
taking off parts;
Do not operate any outdoor cooking gas appliance with a damaged cord, plug, or after the appliance malfunctions
or has been damaged in any manner. Contact the manufacturer for repair;
Do not let the cord hang over the edge of a table or touch hot surfaces;
Do not use an outdoor cooking gas appliance for purposes other than intended;
When connecting, fi rst connect plug to the outdoor cooking gas appliance then plug appliance into the outlet;
Use only a Ground Fault Interrupter (GFI) protected circuit with this outdoor cooking gas appliance;
Never remove the grounding plug or use with an adapter of 2 prongs.
Use only extension cords with a 3 prong grounding plug, rated for the power of the equipment, and approved for
outdoor use with a W-A marking.
3 PRODUCT DATA TABLE
4 PARTS LIST
5 PLANNING FOR INSTALLATION OF YOUR POWER BURNER
5 WHERE TO INSTALL THE POWER BURNER
5 GAS PLUMBING REQUIREMENTS FOR YOUR SLIDE-IN POWER BURNER
5 ENSURING PROPER COMBUSTION AIR AND COOLING AIR FLOW
5 GAS SUPPLY PLUMBING REQUIREMENTS
5 GAS SUPPLY AND MANIFOLD PRESSURES
5 GAS SUPPLY PRESSURE TESTING
7 SAFE USE & MAINTENANCE OF PROPANE GAS CYLINDERS
8 INSTALLING YOUR FIRE MAGIC POWER BURNER
8 CHECK FUEL ORIFICES FOR PROPER SIZE
8 POSITION THE BURNER FOR OPERATION
8 CONNECT THE GAS SUPPLY
9 POWER SUPPLY FOR IGNITION AND LIGHTED KNOBS
10 POWER SUPPLY (MULTIPLE ACCESSORY UNITS)
11 INSTALL THE FLAME COLLIMATOR
11 REMOVE THE CONTROL PANEL TO CHECK RATING PLATE
11 ADJUST THE AIR SHUTTERS
13 LIGHTING (IGNITION) INSTRUCTIONS
13 SHUTTING OFF THE UNIT
14 CARE & CLEANING
15 CHECKING AND CONVERTING GAS TYPE
15 CHECKING AND CONVERTING THE REGULATOR
16 POWER BURNER NOTES PAGE
17 TROUBLESHOOTING
18 WARRANTY