POWER BURNER OWNERS MANUAL

ManualsBrandsFire Magic ManualsBarbecue19 Inch Built-in Power Burner with 60,000 BTU, Cast Brass Burner, Porcelain Cast Iron Grid and Electronic Ignition: Natural Gas, Porcelain Cast Iron Grid

SAFETY WARNINGS & CODES

INSTALLER: Leave these instructions with consumer.

CONSUMER:

Retain for future reference.

INSTALLATION AND OPERATING

INSTRUCTIONS

Important: READ THESE INSTRUCTIONS CAREFULLY BEFORE STARTING INSTALLATION

DANGER

IF YOU SMELL GAS:

1. Shut off the gas to the appliance.

2. Extinguish any open ﬂ ame.

3. Open lid.

4. If odor continues, keep away from the

appliance, and immediately call your

gas supplier or ﬁ re department.

WARNING

1. Do not store or use gasoline or other

ﬂ ammable vapors and liquids in the

vicinity of this or any other appliance.

2. A propane cylinder not connected for use

shall not be stored in the vicinity of this

or any other appliance.

Robert H. Peterson Co. • 14724 East Proctor Avenue, • City of Industry, CA 91746

CODE AND SUPPLY REQUIREMENTS: This power

burner must be installed in accordance with local codes

and ordinances, or, in the absence of local codes, with

either the latest National Fuel Gas Code (ANSI Z223.1/

NFPA 54), and Natural Gas and Propane Storage and

Handling Installation Code (CSA-B149.1).

This appliance and its individual shutoff valves must

be disconnected from the gas supply piping system

when testing the system at pressures in excess of

½ psig (3.5 kPa).

This appliance must be isolated from the gas supply

piping system by closing its individual manual

shutoff valves during any pressure testing of the

gas supply system at pressures up to and including

½ psig (3.5 kPa).

All electrical outlets in the vicinity of the power

burner must be properly grounded in accordance

with local codes or, in the absence of local codes,

with the National Electrical Code, ANSI/NFPA

70, or the Canadian Electrical Code, CSA C22.1,

whichever is applicable.

Keep all electrical supply cords and fuel supply

hoses away from any heated surface.

WARNING

Improper installation, adjustment, alteration,

service, or maintenance can cause injury or

property damage. Refer to this manual. For

assistance or additional information consult

a qualiﬁ ed professional installer, service

agency, or the gas supplier.

POWER BURNER

Certiﬁ ed to: ANSI Z21.58-2007

CSA 1.6-2007

09-41

REV 8 - 1004300923

L-C2-062

Summary of content (16 pages)

PAGE 1
POWER BURNER INSTALLATION AND OPERATING INSTRUCTIONS INSTALLER: Leave these instructions with consumer. CONSUMER: Retain for future reference. Important: READ THESE INSTRUCTIONS CAREFULLY BEFORE STARTING INSTALLATION SAFETY WARNINGS & CODES WARNING DANGER IF YOU SMELL GAS: 1. 2. 3. 4. 1. Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance. 2.
PAGE 2
SÛRETÉ ET CODES D’AVERTISSEMENT INSTALLATION INSTRUCTIONS ET MANUEL DU PROPRIÉTAIRE POWER BURNER DANGER: AVERTISSEMENT: SI VOUS SENTEZ LE GAZ : 1. Coupez l’admission de gaz de I’appariel. 2. Éteindre toute flamme nue. 3. Ouvrir le couvercle. 4. Si l’odeur persiste, éloignez-vous de l’appareil et appelez immédiatement le fournisseur de gaz ou le service d’incendie. 1. Ne stockez pas ou n’employez pas l’essence ou d’autres vapeurs et liquides inflammables à proximité de ceci ou d’aucun autre appareil. 2.
PAGE 3
TABLE OF CONTENTS PRODUCT DATA TABLE PARTS LIST PLANNING FOR INSTALLATION OF YOUR POWER BURNER WHERE TO INSTALL THE POWER BURNER GAS PLUMBING REQUIREMENTS FOR YOUR SLIDE-IN POWER BURNER ENSURING PROPER COMBUSTION AIR AND COOLING AIR FLOW GAS SUPPLY PLUMBING REQUIREMENTS GAS SUPPLY AND MANIFOLD PRESSURES GAS SUPPLY PRESSURE TESTING SAFE USE & MAINTENANCE OF PROPANE GAS CYLINDERS INSTALLING YOUR FIRE MAGIC POWER BURNER CHECK FUEL ORIFICES FOR PROPER SIZE POSITION THE BURNER FOR OPERATION CONNECT THE GAS SUPPL
PAGE 4
PARTS LIST Item 1. 2. or 3. 4. 5. 6. 7. 8. 9. 10. 11. 12. 13. 14. Part No. 3278-06 3545 3545-S 3278-09 3278-01B 3048-03-2 n/a 3001-# 3199-42 3278-14 3016 3015 23278-13 3085 3199-43 Description Cover Grid, porcelain cast iron (black) Grid, stainless steel rod TOOLS REQUIRED FOR INSTALLATION: Flame collimator (stir fry ring) • #2 (Medium) Phillips screwdriver Burner assembly, brass • Two medium size adjustable wrenches or pliers Spring air shutter (2) • 3/8" wrench or socket screwdriver Air shutter (2) inc.
PAGE 5
PLANNING FOR INSTALLATION OF YOUR POWER BURNER Note: This unit should be installed so that it can be removed at a later date if factory service is required. Any protrusion into the power burner enclosure may prevent the unit from sliding into place (see GAS SUPPLY PLUMBING REQUIREMENTS). WHERE TO INSTALL THE POWER BURNER IMPORTANT: THIS POWER BURNER IS FOR OUTDOOR USE ONLY.
PAGE 6
UTILISATION SÛRE ET ENTRETIEN DES CYLINDRES DE GAZ DE PROPANE IMPORTANT POUR VOTRE SÛRETÉ LISEZ ET SUIVEZ TOUS LES AVERTISSEMENTS ÉQUIPÉS DE VOTRE CYLINDRE DE GAZ DE PROPANE. En actionnant cet appareil avec un cylindre de gaz de propane ON DOIT observer ces instructions et avertissements. LE MANQUE DE FAIRE AINSI PEUT AVOIR COMME CONSÉQUENCE UNE INCENDIE OU UNE EXPLOSION SÉRIEUSE.
PAGE 7
SAFE USE & MAINTENANCE OF PROPANE GAS CYLINDERS IMPORTANT FOR YOUR SAFETY READ AND FOLLOW ALL WARNINGS PROVIDED WITH THE PROPANE-GAS CYLINDER. When operating this appliance with a propane-gas cylinder, these instructions and warnings MUST be observed. FAILURE TO DO SO MAY RESULT IN A SERIOUS FIRE OR EXPLOSION. The use of pliers or a wrench should not be necessary. Only cylinders marked “propane” may be used. CYLINDER/CONNECTOR REQUIREMENTS a.
PAGE 8
INSTALLING YOUR FIRE MAGIC POWER BURNER Perform the following checks before installing your power burner: CHECK FUEL ORIFICES FOR PROPER SIZE 1. Your Fire Magic power burner is equipped with fuel orifices for natural gas, unless otherwise indicated. To change the gas type, you must install different orifices to avoid hazardous overheating. (Refer to Table 1 for the proper orifice size) IMPORTANT: When converting orifices for different gas type, the regulator must also be converted for the new gas type.
PAGE 9
INSTALLING YOUR FIRE MAGIC POWER BURNER (Cont.) INSTALL THE FLAME COLLIMATOR Important: 1. Place the flame collimator over the burner with the tabs and cutouts resting on the inner liner shelf, as shown in Fig. 9-1. Flex the front of the collimator towards the burner until the cut outs fit down around the collimator support. This will lock your collimator into place. The flame collimator acts as a barrier for windy conditions and creates higher BTU concentration in the cooking grid.
PAGE 10
ALLUMAGE DES INSTRUCTIONS (D’ALLUMAGE) Lisez toutes les instructions avant l’allumage, et suivez ces instructions chaque fois vous lumière le unité. ÉCLAIRAGE ÉLECTRONIQUE Note: ÉCLAIRAGE MANUEL ATTENTION: Attendez toujours cinq minutes le gaz pour se ATTENTION: dégager Attendezaprès toujours (5) minutes le gaz que cinq n’importe quelle tentative pour se dégager après que n’importe quelle non réussie d’éclairage. L’éclairage électronique exige une batterie installée de 9 volts avec une bonne charge.
PAGE 11
LIGHTING (IGNITION) INSTRUCTIONS Read all instructions before lighting, and follow these instructions each time you light the unit. ELECTRONIC LIGHTING MANUAL LIGHTING CAUTION: Always wait five minutes for gas to clear CAUTION: Always wait five (5) minutes for gas to after any unsuccessful lighting attempt. clear after any unsuccessful lighting WARNING: DO NOT put hand directly above the burner attempt. 1. Open lid(s) or remove cover(s) from burner(s) to be lit.
PAGE 12
CARE & CLEANING CARE AND CLEANING APPLIANCE MUST BE COMPLETELY COOL WHEN CLEANING. DO NOT SPRAY ANY CLEANER OR LIQUIDS ON THE APPLIANCE WHEN HOT. Stainless steel surfaces when exposed to temperatures produced by the grilling process will change color. The stainless steel will change color from silver to brown and blue. This can be removed by using Fire Magic Stainless Steel Cleaner (3581-1). Clean your appliance by fi rst using Fire Magic Barbecue and Grill Cleaner (part #3580-1) to remove grease and dirt.
PAGE 13
CHECKING AND CONVERTING GAS TYPE This unit comes from the factory configured for WARNING one type of gas, as marked on the label behind the HAZARDOUS OVERHEATING WILL OCCUR control panel. IF A NATURAL-GAS ORIFICE IS USED WITH PROPANE GAS. IF YOU ARE NOT SURE IF THE Converting this unit to burn a different type of CORRECT ORIFICES ARE INSTALLED, OR IF AN gas requires a conversion kit from the factory.
PAGE 14
POWER BURNER NOTES PAGE Please use this page to record any information about your power burner that you may want to have at hand.
PAGE 15
REPLACING THE IGNITOR BATTERY To replace the 9V battery powering the ignitors, pull out the battery holder located on the outside of the control panel. It may be necessary to lift the drawer up slightly before it will pull out. Disconnect the battery from the connector and replace it connecting the new battery and closing the drawer (see Fig. 15-1). Fig. 15-1 TROUBLESHOOTING If you have trouble with the unit, please use this list to identify the problem.
PAGE 16
WARRANTY LIFETIME WARRANTY - Fire Magic® cast stainless-steel burners, stainless-steel rod cooking grids, and stainless-steel housings are warranted for as long as you own your Fire Magic® grill. FIFTEEN-YEAR WARRANTY - Fire Magic® cast brass burners, brass valves, backburner assemblies (except ignition parts), and manifold assemblies are warranted for 15 years from the date of purchase of your Fire Magic® grill.