User Manual Single Side Burner, Aurora

Fig. 19-1 Tab may interfere when sliding in unit

Fig. 19-2 Tab slightly bent in for clearance

SLIDE UNIT INTO ENCLOSURE

Slide the unit into place. Do not to pinch, kink, or

damage the gas connector line.

Note: Each side of the unit has a tab just behind

the control panel. These tabs prevent the

control panel from moving inward. If the

tabs interfere with the unit sliding in (see

Fig. 19-1), use pliers to bend them inward

so that they clear the enclosure sides.

Leave the tabs slightly out to ensure they

still keep the control panel from moving

inward (see Fig. 19-2).

POSITION THE BURNER CAP

Place the burner cap so it is centered over the burner.

Ensure that it rests securely in place.

INSTALLATION (cont.)