User Manual Single Searing Station

27
CONVERT/CHECK SEARING STATION BURNER
ORIFICE
1. Remove the Searing Station lid and lift off the cooking
grid.
2.
Remove the control panel. See the CONTROL PANEL
REMOVAL section for details.
3. Carefully lift the burner up, allowing the tabs to clear the
slots in the rear burner rest. Slowly pull the gas-supply
tube away from the orifi ce located inside the circular
opening in the front fi rewall of the unit. (See Fig. 27-1
and Fig. 27-2.)
Note: The igniter wire length provides for the burner to be
removed allowing access to the orifi ce. Should the
burner need to be completely removed; the igniter
must be unscrewed.
4. Using a
3
/
8
" socket, remove the orifi ce from the orifi ce
holder (see Fig. 27-3) and check the number stamped
on the face.
5. If an orifi ce change is necessary, replace the orifi ce
with the correct-size.
6. Replace the gas-supply tube over the orifi ce, aligning
the burner into the rear burner rest. Re attach the
electrode wire.
7. Replace the control panel. Replace the drip tray, control
knob, cooking grid, and lid.
Orifi ce
(View from inside of unit)
Remove orifi ce
Fig. 27-1 Remove burner
Fig. 27-2 Orifi ce location
Fig. 27-3 Remove orifi ce to convert/check
CONVERT GAS TYPE / CHECK BURNER ORIFICES (cont.)