User Manual Single Searing Station

3
Do not strike or scrape the ceramic portion of the burner with hard tools, as the material may crack, chip,
or break. Prevent any grease, water, or other foreign material from getting into the ceramic portion of the
burner , especially when cold. Always wait for the burner to heat up to a well-distributed red glow before
placing food on the cooking grid. When a burner is hot, it will vaporize small amounts of grease that drip
on it. Always cover the burner when not in use. Keeping the ceramic portion of the burner free of foreign
substances will allow the gas to circulate and burn over the entire heating surface, allowing for powerful
and even cooking over the life of the burner .
CONTENTS
CAUTION
REV 0 - 1601191040
L-C2-450
GETTING STARTED
CAUTION ....................................................................... 3
SINGLE SEARING STATION PARTS LIST ..................... 4
MODEL SPECIFICATIONS ............................................. 5
COUNTERTOP OVERHANG ........................................ 5
MODEL SPECIFICATIONS TABLE ............................... 5
SUBSTRATE .............................................................. 6
SINGLE SEARING STATION DIMENSIONS TABLE .......... 6
ELECTRICAL SAFETY ................................................ 7
SINGLE SEARING STATION WIRING DIAGRAM ............. 7
MAINTENANCE AND SAFETY INFORMATON ............. 8
SINGLE SEARING STATION FLAME PATTERN .............. 8
ELECTRICAL CONNECTIONS ..................................... 8
INSTALLATION REQUIREMENTS ................................ 9
EXHAUST REMOVAL ............................................... 10
ENSURE PROPER COMBUSTION AIR AND
COOLING AIRFLOW
................................................10
GAS-SUPPLY PLUMBING REQUIREMENTS ................10
ENCLOSURE REQUIREMENTS ................................... 11
VENTILATION (ALL ENCLOSURES) ........................... 11
WHEN A PROPANE (L.P.) CYLINDER IS USED IN
THE ENCLOSURE
................................................... 11
PROPANE SAFETY INFORMATION ............................ 12
WARNING .............................................................. 12
INSTALLATION SAFETY GUIDELINES........................ 12
OPERATING THE UNIT SAFELY AND CORRECTLY .. 12
SAFE USE & MAINTENANCE OF
PROPANE GAS CYLINDERS ....................................... 13
INSTALLATION
INSTALLATION ............................................................15
COUNTER PREPARATION .........................................15
CONNECT THE GAS SUPPLY .....................................15
CONNECT TO A POWER SOURCE ..............................16
POWER SUPPLY (MULTIPLE ACCESSORY UNITS) .......18
SLIDE UNIT INTO ENCLOSURE .................................19
NOTES PAGE ................................................................20
USE, CARE, & SERVICE
LIGHTING (IGNITION) INSTRUCTIONS ...................... 21
ELECTRONIC LIGHTING ..........................................21
MANUAL LIGHTING .................................................21
SHUTTING OFF THE UNIT ........................................ 21
INFRARED BURNER OPERATION ...............................23
CARE & CLEANING .....................................................24
CONTROL PANEL REMOVAL ......................................25
CONVERT GAS TYPE / CHECK BURNER ORIFICES ...26
NOTES PAGE ................................................................28
TROUBLESHOOTING ...................................................29
WARRANTY .................................................................30