User Manual

REV 1 - 1511190815
L-C2-432
1
ROBERT H. PETERSON CO. • 14724 East Proctor Avenue • City of Industry, CA 91746
COOKING AREA: 14" x 7"
This warming rack extender is for use with the following
grill series only: A530, A660, A790,
E660, E790, & E1060
INSTALLATION
1. Ensure the grill is completely cool, the knobs
are in the off position, and the gas supply to
your grill is turned off.
2. Wash all of the warming rack extender components
(with soap and water) before assembly.
3. Open grill oven hood.
4. Position the extender above the warming rack, lower
the hooks into the rear of the rack (Fig. 1-1, A), then
lower the front (Fig. 1-1, B).
5. Repeat if additional extenders were purchased.
The extender may be removed and stored when desired.
CLEANING
It is recommended that the warming rack extender be
cleaned after each use. It can easily be removed and
fi t in a dishwasher.
1. Remove the warming rack extender(s) from the
grill by reversing step 4 above.
2. Clean as needed.
INSTALLER: Leave these instructions with consumer.
CONSUMER: Retain for future reference.
WARMING RACK EXTENDER
Model # 3682A
Fig. 1-2 Warming rack extender in place
Fig. 1-1 Install warming rack extender
B
A