Installation Guide

To remove the control panel:

1. Turn the control knobs to the OFF position.

2. Remove the drip tray.

3. Pull the control knobs from the stems and set aside.

4. Using a Phillips screwdriver, unscrew and remove the control panel fastener screws and washers

(located on the left and right front face of the control panel). Retain the screws for later re-installation.

5. Carefully open the control panel by lifting and pulling the control panel from the frame, allowing it to

rest on the internal chain(s).

Important: When opening, take caution to not damage any wiring.

6. If wire disconnections are required, reference the wire diagram in the MODEL SPECIFICATIONS

section in this instruction manual or the wire diagram label afﬁ xed to the inside of the control panel.

Note: Secure any disconnected wires (coming from the inside of the unit) to prevent them from falling in.

Note: Whenever reconnecting any wires, apply a small amount of dielectric grease to the male connector,

then make the connection.

Important: Dur

ing reinstallation; prior to opening the gas shutoff valve, be sure the control knobs are

in the OFF position.

CONTROL PANEL REMOVAL