Instructions

4
REV 6 0906230824
L-C2-11109
PREPARING FOR INSTALLATION
Your double sideburner is designed to complement
your Fire Magic grill. It provides a convenient,
effi cient cooking surface for side dishes that
require bottom heat only.
TOOLS REQUIRED
The double sideburner has been pre-assembled.
You need only a pair of wrenches, pliers, or vice
grips for the gas connection.
CODE AND SUPPLY REQUIREMENTS
This burner must be installed in accordance with
local codes and ordinances, or, in the absence
of local codes, with the National Fuel Gas Code,
ANSI Z223.1.
This appliance and its individual shutoff valve
must be disconnected from the gas supply piping
system when testing the system at pressures in
excess of
1
/
2
psig (3.5 kpa).
The appliance must be isolated from the gas supply
piping system by closing its individual manual shutoff
valve during any pressure testing of the gas supply
system at pressures up to and including
1
/
2
psig
(3.5 kpa).
Do not install this unit under unprotected
fl ammable surfaces. Do not install or use this
appliance inside a building, garage, or any
other covered area. It must not be used in or
on recreational vehicles or boats.
This is a built-in type unit designed to fi t into open-
front enclosures. The control panel of the unit is
removable for gas hookup, servicing, and burner
adjustment. The control panel must be removable
after you install the unit.
INSTALLER NOTE: This unit should be installed
so that it can be removed at a later date if factory
service is required. Any protrusion into the double
sideburner enclosure may prevent the unit from
sliding into place (see GAS SUPPLY PLUMBING
REQUIREMENTS, on page 5).
ENSURING PROPER COMBUSTION AIR AND
COOLING AIR FLOW
You must maintain proper air fl ow for your Fire Magic
double sideburner to perform as it was designed
(Fig. 4-1). If airfl ow is blocked, overheating and poor
combustion will result. Make sure not to block the 1"
front air inlet along the bottom of the control panel
or more than 75% of the support grid surface with
pans or griddles.
WHERE TO INSTALL YOUR
DOUBLE SIDEBURNER
FOR OUTDOOR USE ONLY.
ELECTRICAL OUTLETS
Electrical outlets in the vicinity of this appliance
must be properly grounded and GFI equipped.
Important: This unit may be installed into combustible
framing (wood, for instance) provided
there is a minimum of a
1
/
2
" airspace
between the sides of the unit and any
combustible material. This hanger
requires 1
1
/
2
" of countertop on each
side and back to support the unit.
Sideburner
Sideburner
Countertop
Counter Counter
Maintain air gap all the
way down (back and
side) under countertop
Edge of
counter
cut-out
2
1
/
4
"
Hanger
2
1
/
4
"
Min.
1
/
2
"
Max.
3
/
4
"
air gap to all
combustible
material
Fig. 4-1 Top View
Fig. 4-2 Front View
Stainless
steel
hanger
Hanger