Installation Instructions

POWER SUPPLY FUSE REPLACEMENT

1. The power supply box is located on the right

side of the grill (reference the PARTS LIST).

2. Using a phillips screwdriver, remove the 6 large

screws found on the cover of the power supply

box (see Fig. 33-1).

3. Slightly pull out the box to expose the wiring,

and disconnect the wire harness (see Fig. 33-2).

Completely remove the box from the grill for

ease of fuse replacement.

4. Remove the 4 small screws found on the cover

of the power supply box (see Fig. 33-3).

Note: The 2 center screws do not need to be

removed.

5. Carefully open the box by pulling its cover away.

You may need to feed the wire harness into the

box to provide enough slack to open on the

other end. Then “push in and twist” the fuse

holder (red wire), exposing the fuse. See Fig.

33-4.

6. Replace the fuse accordingly (3AG 2 AMP).

Slightly pull out box and disconnect wire harness

Fig. 33-2

Disconnect

here

Remove 6 large screws

Fig. 33-1

Carefully open box and replace fuse (red wire)

Fig. 33-4

Remove 4 small screws

Fig. 33-3