Quick Start Guide

REV 3 - 1306270115
L-C2-335
5-Test
1. Open the lid and remove any cover(s) of the burner(s) to be lit.
2. Turn all gas control knobs to the OFF position.
3. Turn the gas-supply valve on.
4. Depress the desired control knob for 5 seconds, then, while pressing turn it
counterclockwise to the HI LIGHT position. Once the burner lights, release the control
knob. (Repeat this step for each additional burner.)
CAUTION: If burner does not light within 5 seconds, IMMEDIATELY depress the knob and
turn it to the OFF position. Wait 5 minutes before repeating step 4. If the burner
does not light after repeated attempts, refer to the Lighting Instructions in your
Owners Manual.
4-Grill Setup
Parts Placement Checklist
Place the following items according to their position and orientation
in Fig. 4-1:
Flavor grids, cooking grids, heat zone dividers, backburner cover,
warming rack, meat probe.
Leave pre-installed E-burners in place to maintain proper alignment.
Backburner Cover
Hook the backburner cover over the top of the backburner to protect
the backburner from grease, dust and dirt when it is not in use.
Remove cover before use.
Warming Rack
The warming rack comes pre-installed. Remove zip ties before use.
Consult the owner’s manual to remove or replace.
Fig. 4-1
Cooking Grid
Flavor Grid
(not with IR)
E-burner
*
(comes pre-
installed)
Backburner
cover
Warming
rack
Power Hood motor
assembly box (optional)
Front support
adjustment
screws (2)
Note: For infrared burner equipped grills, see
detailed instructions included in your
owners manual.
Power supply
Heat zone
divider
Drip tray
(with lighting instructions)
Backburner
Drip tray
liners
Fig. 5-2
Left
main burner control
knob
Right
main burner
control knob
Digital
thermometer
Center right main
burner
control knob
Center left main
burner
control knob
Smoker drawer
burner control
knob
Power hood
control switch
(if equipped)
Right backburner
control knob
(if equipped)
Left back-
burner
control knob
(if equipped)
Pull-out drip
tray
Meat
probe
Wood chip
tray
Fig. 5-1 - Burner valve control knob
6-Propane Safety
FOR PROPANE CONFIGURATIONS; READ ALL SAFETY INSTRUCTIONS AND WARNINGS REGARDING THE USE OF PROPANE
GAS FOUND IN YOUR OWNERS MANUAL.
Wood chip
tray
WHEN OPERATING THIS
APPLIANCE WITH PROPANE, ALL
INSTRUCTIONS AND WARNINGS
MUST BE OBSERVED. FAILURE TO
DO SO MAY RESULT IN A FIRE OR
EXPLOSION CAUSING SERIOUS
INJURY OR DEATH.
OFF
HI
LIGHT
LOW
TO
TURN OFF
T O TURN ON
Read setting
here
HIGH to
LIGHT
Read setting here
(OFF position shown)
To Turn OFF
To Turn ON
Use
HI (high)
to light
Press
knob in
to turn
Gas Flow
Indicator
For your convenience and safety;
when the control knob is in the
ON position, the gas fl ow indicator
will change from blue to red. (Red
indicates gas fl ow.) See Fig. 5-1.
Master
switch
The master switch (Fig. 5-2) controls
the power to all lights, igniters, and the
thermometer. It allows the power to be
turned on or off for safety and convenience.
The switch will need to be turned on prior to
each grill use, and turned off after each use.
*
The burner ports
and carry-over slots
must be kept clean to
ensure proper ignition
and operation.