Digital Thermometer Instructions

REV 0 - 1009131447
L-C2-348
1
ECHELON DIAMOND
DIGITAL THERMOMETER
INSTALLER: Leave these instructions with consumer.
CONSUMER: Retain for future reference.
This digital thermometer is for replacement on an Echelon
Diamond grill. To install, follow the steps below:
1. Be sure the grill is completely cool and the power to the
grill is off.
2. Locate the old thermometer on the grill control panel
between the knobs. Remove it from the grill by slightly
sliding it to the left, then lifting the right side outward
until it clears the control panel.
CAUTION: Remove carefully as the wire harnesses will still
be attached to the back of the thermometer.
3. The wire harnesses will be taped together. CAREFULLY
cut the tape.
Important: Take note of the way the harnesses are taped,
as once the new thermometer is connected;
the new harnesses will need to be similarly
taped.
4. CAREFULLY pull apart the 3 wire harnesses at the
connectors, as shown in Fig. 1-1.
5. Connect the new thermometer wire harnesses to the
exposed wire harnesses coming out of the grill (see
Fig. 1-1).
CAUTION: The wire harnesses must be properly
connected. All 3 wire harnesses have differently
sized or shaped connectors to ensure a proper
install.
6. Ensure that all the wire harnesses are properly taped
using high temperature electrical tape.
7. Carefully install the thermometer into the cutout on the
control panel.
MENU
SET
Fig. 1-1 Removing / connecting
digital thermometer
Thermometer cutout
Digital
thermometer
Wire
connections
Grill
control panel

Summary of content (4 pages)