Installation Instructions

ManualsBrandsFire Magic ManualsOutdoor BarFire Magic Echelon Collection 2DSSD

REV 6 - 1402170710

L-C2-274

INSTALLER: Leave these instructions with consumer.

CONSUMER: Retain for future reference.

ROBERT H. PETERSON CO. • 14724 East Proctor Avenue • City of Industry, CA 91746

BEVERAGE CENTER

Stand Alone Model # 2D-SSA, 2D-SSD

Built-In Model # 1D-SSA, 1D-SSD

INSTALLATION

INSTRUCTIONS & OWNER’S

MANUAL

IMPORTANT: READ ALL INSTRUCTIONS CAREFULLY BEFORE STARTING INSTALLATION OR USE.

WARNING

This electrical appliance is equipped with a three-

pronged (grounding) plug for your protection against

shock hazard and should be plugged directly into

a properly grounded three-prong GFCI protected

receptacle. Do not cut or remove the grounding prong

from the plug.

Do not operate any appliance with a damaged cord

or plug, after an appliance malfunction, or after the

appliance has been dropped or damaged. Return the

appliance to your dealer or authorized service facility for

inspection, repair, or electrical/mechanical adjustment.

ELECTRICAL GROUNDING

To protect from electrical shock, this appliance must

be grounded while in use.

If an extension cord is used, it must be a three-pronged

cord listed for outdoor use. These cords are identiﬁ ed by

the marking: "Suitable for use with outdoor appliances;

store indoors while not in use." The cord must be rated

at or above the rating of this appliance as speciﬁ ed on

the rating plate.

GFCI receptacle

Test and reset

switches

Grounding

plug

Fig. 1-1 GFCI receptacle

2D-SSD shown

Summary of content (12 pages)

PAGE 1
BEVERAGE CENTER Stand Alone Model # 2D-SSA, 2D-SSD Built-In Model # 1D-SSA, 1D-SSD INSTALLATION INSTRUCTIONS & OWNER’S MANUAL INSTALLER: Leave these instructions with consumer. CONSUMER: Retain for future reference. 2D-SSD shown IMPORTANT: READ ALL INSTRUCTIONS CAREFULLY BEFORE STARTING INSTALLATION OR USE.
PAGE 2
STAND ALONE REPLACEMENT PARTS LIST Item Description Part No. Qty. 1. Sink 3587 1 2. Faucet 3588 1 3. Blender kit 3284-2 4. Cutting board 5. Item Description 9. Part No. Qty. Overhead light bulb* 24187-15 2 10. Paper towel rack 25387-11 1 1 11. GFI / receptacle & power supply 24387-18 1 1D-S-07 1 12. Waste basket 2D-S-14 1 Condiment holder with lid 1D-S-08 2 6. Food/Beverage holder with lid 2D-S-09 2 13.
PAGE 3
BUILT-IN REPLACEMENT PARTS LIST Item Description Part No. Qty. 1. Sink 3587 1 2. Faucet 3588 1 3. Blender kit 3284-2 1 4. Cutting board 1D-S-07 1 5. Condiment holder with lid 1D-S-08 2 6. Electrical junction box 24187-18 1 7. Overhead light lens (if equipped)* 24187-26 2 8. Overhead light bulb (if equipped)* 24187-15 2 9. or Storage drawer (w/glides) Diamond storage drawer (w/glides) 1D-S-12 1D-SD-12 1 1 10.
PAGE 4
INSTALLATION BUILT-IN UNITS WARNING Have all electrical work performed by a licensed professional electrician. Prepare a cut-out in the countertop as specified in Table 1 and shown in Fig. 4-1. Note additional clearance required to the rear for the blender cover to open fully.
PAGE 5
ASSEMBLY PLUMB OR SET UP WASTE WATER DISPOSAL The sink comes with a plastic trap and drainpipe extending just below the sink (see Fig. 5-1). A waste water container may be placed under the sink. It must then be periodically checked and emptied when full. Alternately, a permanent waste water drain may be plumbed from under the sink out through the knock-out in the rear left (stand alone only) or the enclosure (built-in only) to an appropriate drain. Observe all locally applicable codes.
PAGE 6
ASSEMBLY (cont.) drawer. Locate the blender cord through the opening on the right above the receptacle (Fig. 6-1) and plug it in. Ensure the blender rests in the tray in front of the domed lid. See blender instructions for additional details on blender installation, use, and maintenance. Test the blender and electrical connection by applying and turning off power without the container in place. WARNING Do not use blender in rain or wet conditions.
PAGE 7
ASSEMBLY (cont.) INSTALL PAPER TOWEL HOLDER (STAND ALONE ONLY) Unpack the paper-towel holder hanger, squeeze the open ends together slightly, and insert them into the mounting bracket on the front right (Fig. 7-1). Next, release the hanger so that the ends poke out through the holes in the top and bottom of the mount. Fig.
PAGE 8
OPERATION (cont.) DOORS AND DRAWERS The left top drawer (Fig. 8-1) is for tool/utensil storage. The blender container and other such items may be stored effectively in this drawer. The right top drawer is for storage of clean ice. Open the drawer, make sure the drain plug is in place (Fig. 8-2), and pour the ice into the basin. Close the drawer to protect the ice from wind and debris and to keep it shaded.
PAGE 9
OPERATION (cont.) TO LOWER OR RAISE SHELVES (STAND ALONE ONLY) A. To lower the shelf, grasp the shelf and lift from the hinges (Fig. 9-1). WARNING Do NOT place fingers near hinge when closing. Important: Wine bottle/food containers must be removed prior to collapsing the left-hand shelf. B. To raise the shelf, grasp the shelf away from the hinge and lift upward until the hinge comes out of the retainer slot.
PAGE 10
CLEANING & MAINTENANCE CHANGING THE BULBS (IF EQUIPPED) Important: ONLY REPLACE WITH 12V / 10 WATT HALOGEN BULB(S). WARNING: To protect from potentially sharp sheet metal and glass, wear gloves and safety glasses during this procedure. 1. Turn off all electrical sources. Important: Place one hand directly below the glass lens and prepare to catch it when it is detached. Fig. 10-1 Pry glass lens out 2.
PAGE 11
CLEANING & MAINTENANCE (cont.) CARE AND CLEANING Clean up spills as required with a damp cloth or sponge or a non-abrasive low-acid cleaning solution. For heavy cleaning, clean with a quality stainless-steel cleaner as necessary. Follow the directions on the cleaner. Always wipe in the direction of the grain (see Fig. 11-1). You may find it useful to first remove the blender from the stainless-steel housing (see the PLACE BLENDER IN BLENDER MOUNTING section, or separate blender instructions).
PAGE 12
WARRANTY PETERSON FIRE MAGIC GRILLS AND ACCESSORIES LIMITED WARRANTY Robert H. Peterson Co. ("RHP") warrants your Fire Magic® grill to be free from defects in material and workmanship. Fire Magic® cast stainless-steel burners, stainless-steel rod cooking grids, and stainless-steel housings are warranted for as long as you own your Fire Magic® grill -- LIFETIME. (Except as noted below.) Fire Magic Choice stainless steel tubular burners are warranted for TWENTY (20) YEARS.