Instructions / Assembly

ManualsBrandsFire Sense ManualsHeating, Ventilation, and Air Conditioning47,000 BTU Stainless Steel Propane Gas Patio Heater

Deluxe Patio Heater

Item#: 11201, 61315 Model: PH03-S/PH03-SS

Questions, problems, missing parts?

Before returning to your retailer, our exceptional customer service is available.

Call us toll-free at (866) 985-7877, email us at cservice@welltraveled.net, or go online

and live chat at www.wtliving.com. Our hours are: 9 a.m. – 6 p.m., EST, Monday – Friday

FOR YOUR SAFETY

If you smell gas:

1. Shut off gas to the appliance.

2. Extinguish any open ame.

3. If odor continues, immediately call

gas supplier.

FOR YOUR SAFETY

Do not store or use gasoline or other

ammable vapors and liquids in the

vicinity of this or any other appliance.

WARNING

For Outdoor Use Only

Comfort, Quality & Style Since 1998

ATTACH YOUR

RECEIPT HERE

Keep a copy of your proof of

purchase or order conrmation

which will be needed if you

need to contact us about

warranty coverage.

Purchase Date:

Summary of content (14 pages)

PAGE 1
Comfort, Quality & Style Since 1998 Deluxe Patio Heater Item#: 11201, 61315 Model: PH03-S/PH03-SS FOR YOUR SAFETY If you smell gas: 1. Shut off gas to the appliance. 2. Extinguish any open flame. 3. If odor continues, immediately call gas supplier. FOR YOUR SAFETY Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance.
PAGE 2
www.wtliving.com Table of Contents Table of Contents Page 2 Before You Begin Page 2 Safety Information Page 3 Package Contents Page 4 Hardware Contents Page 4 Assembly Page 5-9 Operating Instructions Page 10-11 Care and Maintenance Page 12 Troubleshooting Page 13 Warranty Information Page 14 BEFORE YOU BEGIN Please read and understand this entire manual before attempting to assemble, operate or install this appliance.
PAGE 3
SAFETY INFORMATION DANGER CARBON MONOXIDE HAZARD • This appliance can produce carbon monoxide which has no odor. • Using it in an enclosed space can kill you. • Never use this appliance in a enclosed space such as a camper, tent, car or home. WARNING • Improper installation, adjustment, alteration, services or maintenance can cause injury, death or property damage. • Read the installation, operating and maintenance instructions thoroughly before installing or servicing this equipment.
PAGE 4
PACKAGE CONTENTS 1 2 3 4 5 6 7 8 PART DESCRIPTION QUANTITY 1 2 3 4 5 6 7 8 9 au al am an Center Reflector Cap 1 Reflector Panels 3 Head Assembly 1 Gas Hose attached to Head Assembly 1 Upper Post 1 Cylinder Cover 1 Lower Post 1 Post Support 1 Regulator (with 1-foot Hose) 4 Post Mounts 1 Base 1 Waterbox (pre-assembled to Base) 3 Wheel Assembly 1 HARDWARE CONTENTS 9 ao Large Bolt, Bracket au (Pre-assembled for Base) Qty: 3 ap Medium Bolt, Flange Nut (Pre-assembled for W
PAGE 5
ASSEMBLY PREPARATION Before beginning assembly of this appliance, make sure all parts are present. Compare all parts with package contents list and hardware contents as listed on page 4 of this manual. If any part is missing or damaged, do not attempt to assemble this product. Contact customer service for replacement parts.
PAGE 6
www.wtliving.com 4 Place Waterbox back under Base and use your phillips head screwdriver to screw back in the 4 screws from Base to the Waterbox. Note: You may find it easier to fill the waterbox prior to attaching wheels, in step 5. To fill, pull open the plastic cap on top of the waterbox and fill with water or sand. Place the plastic cap back on top. 5 Locate Wheel Assembly Nuts . Turn Base and 2 Medium Bolts and Flange 4 so that holes for attachment of Wheel Assembly are facing you.
PAGE 7
ASSEMBLY 7 Place the Post Support on the top of Post Mounts attach using the Tall Bolt and Small Nut and . Repeat with remaining holes. Hand tighten initially then tighten with the Wrench when all nuts and bolts have been inserted. Hardware Used: 6x Tall Bolt and Small Nut 7 8 Attach the Lower Post 4 Small Bolts the Wrench to the Post Support 8 by using . Hand tighten initially then tighten with when all bolts have been inserted.
PAGE 8
ASSEMBLY 11 Attach Reflector Studs Assembly to the top of the Head by inserting 1 Reflector Stud into the hole on the top of the Head Assembly. Tighten stud securely. Repeat with the other 2 Reflector Studs. 12 Hardware Used: 3x Reflector Stud 12 Remove the 4 pre-assembled screws and lock washers from the base of the Head Assembly Route the Gas Hose and set aside.
PAGE 9
ASSEMBLY 13 Install Reflector. NOTE: MAKE SURE TO Remove the blue reflector tape ON REFLECTOR PIECES PRIOR TO ASSEMBLY! Assembly Tip: If necessary for proper alignment of reflector sections, loosen each screw prior to further assembly and retighten after sections are aligned. Slide two Reflector Panels together. Insert one Small Screw screw on Cap Nut Panels front underneath and loosely from top. Repeat with the other Reflector .
PAGE 10
OPERATION WARNING FOR YOU SAFETY: DO NOT touch or move heater for at least 45 minutes after use. Allow emitter and dome to cool before touching. IGNITER OFF P ht PUSH IN rn HIGH o tu OFF P us ht o tu rn LIGHTING INSTRUCTIONS Note: For initial start-up or after any cylinder change, hold the Control Knob in for 2 minutes to purge air from all gas lines before proceeding. When lighting the burner make sure that the Control Knob is held in while pressing the igniter button.
PAGE 11
OPERATING CAUTION: Avoid inhaling fumes emitted from the heater’s first use. Smoke and odor from the burning of oils used in manufacturing will appear. Both smoke and odor will dissipate after approximately 30 minutes. The heater should NOT produce thick black smoke. When heater is ON: Emitter screen will become bright red due to intense heat. The color is more visible at night. Burner will display tongues of blue flame.
PAGE 12
CARE AND MAINTENANCE Check your hose assembly The installation of fixed appliance shall only be carried out by competent persons and be in accordance with the relevant codes of practice. Warning: This appliance requires a gas hose and regulator. Check with your gas supplier and or product supplier. Regularly check the gas hose and if necessary, replace the gas hose. Prior to use, check for damage parts such as hoses, regulator, pilot or burner.
PAGE 13
Troubleshooting PROBLEM Main burner will not light POSSIBLE CAUSE CORRECTIVE ACTION Gas valve may be off Turn gas valve ON Fuel tank may be empty Refill LPG tank Orifice blocked Clean or replace orifice Air in supply system Purge air from lines. Open gas lines and depress Control Knob for 2-3 mins.
PAGE 14
Comfort, Quality & Style Since 1998 1 YEAR LIMITED WARRANTY Customers in the Continental US All components are warranted for a period of 1 year after date of purchase by the original owner against defects in materials and workmanship under normal use. This warranty does NOT cover normal wear and weathering, assembly and/ or maintenance OR use in a commercial application if model is not designated as a commercial model.