Instructions / Assembly

Lighting

1. Make sure control knob is in the “Off” position.

2. Push in and rotate the gas control knob to “Pilot” position. Depress gas control

know for 30 seconds to allow air to purge. Once gas reaches burner, depress

igniter button while holding gas control knob in.

3. Once burner is lit, hold control knob in for at least 30 seconds and release.

4. If burner does not stay lit, turn control knob to “Off” position and wait 5 minutes

and repeat 2 and 3.

5. Once burner is lit, rotate control knob to desired heating level (LO: low; HI:

high).

If you experience any ignition problem, turn off the heater and gas supply and

consult “Troubleshooting” on page 12.

Caution

Avoid inhaling fumes emitted from heater’s first use. Smoke and odor from

the burning of oils used in manufacturing will appear. Both smoke and

odor will dissipate after approximately 30 minutes. The heater should NOT

produce think black smoke.

Note: The burner may be noisy when initially turned on. To eliminate excessive

noise from the burner, turn the control knob to LO position. Then, turn the knob to

level of heat desired.

When heater is ON:

Emitter screen will become bright red due to intense heat. The color is more

visible at night.

Burner will display tongues of blue flame. These flames should not be yellow or

produce thick black smoke, indicating an obstruction of airflow through the

burners.

If yellow flame is detected, turn off heater and gas supply and consult

“Troubleshooting” on page 12.

Re-lighting

Note: For your safety, control knob cannot be turned to “Pilot” without first

depressing control knob in “Off” position and then rotating to “Pilot”.

1. Turn gas control knob to “Off”.

2. Wait 5 minutes to let gas dissipate before attempting to relight burner.

3. Repeat the “Lighting” steps 2 and 3.

To turn heater OFF:

1. Rotate gas knob to “Off” position. Normally, burner will make a slight popping

sound when extinguished.

2. Remove door plate.

3. Unscrew gas canister from regulator and store gas canister AWAY from heater

when heater is not in use.

4. Close door plate.

Note: After use, some discoloration of the emitter screen is normal.