Instructions / Assembly

2
Step 2:
Once the Dimmer Switch Module has been secured to the pole, plug the cord from the Infrared Heater into
the Dimmer Switch module. Then to use the Infrared Heater, plug the Dimmer Switch module cord into a
wall outlet. This appliance must be used with an outlet that has been installed and grounded in accordance
with local codes and ordinances. Make sure the appliance is connected to an outlet having the same
configuration as shown in the figure below. DO NOT use an adapter with this product. Check with a licensed
electrician if the grounding instructions are not understood completely or if the wall outlet does not match
the plug shown below. We recommend that you use a DEDICATED LINE for operation of this
appliance as it will draw 1500 watts/13 amps during operation.
Step 3:
To operate the Dimmer Switch Module, lift the transparent plastic cover to expose the knob. Make sure you
begin with the knob in the "OFF" position. Then turn the knob clockwise to the "MIN" position. To increase
the heat, continue to turn the knob clockwise toward the "MAX" position (NOTE: MIN wattage is 200w and
MAX is 1500w.) From the "MAX" position, turn the knob counterclockwise towards "MIN" to decrease the
wattage. Make sure to turn the knob to "OFF" and unplug the Dimmer Switch Module from the wall outlet
when the heater is NOT in use.