Instructions / Assembly

13
OPERATION INSTRUCTIONS
DANGER
CARBON MONOXIDE HAZARD
For outdoor use only. Never use inside house, or other
unventilated or enclosed areas This fire pit consumes air.
().oxygen Do not use in unventilated or enclosed areas to
avoid endangering your life.
Very hot while in a operation!
Never lean over the fire pit while in use.
Do not touch surfaces while the fire pit is in
operation wait until the fire pit has cooled down after use,.
Failure to comply with these instructions may result in
serious bodily injury.
WARNING
Before Turning Gas Supply ON:
1 Your fire pit was designed and approved for outdoor use only Do NOT use it inside a building..,
garage or any other enclosed area,.
2 Make sure surrounding areas are free of combustible materials gasoline and other flammable.,,
vapors or liquids.
3 Ensure that there is no obstruction to air ventilation Be sure all gas connections are tight and..
there are no leaks.
4 Be sure the cylinder cover is clear of debris Be sure any component removed during assembly..
or servicing is replaced and fastened prior to starting.
Before Lighting:
1 Fire pit should be thoroughly inspected before each use and by a qualified service person at least.,
annually If relighting a hot fire pit always wait at least 5 minutes., .
2 Inspect the hose assembly for evidence of excessive abrasion cuts or wear Suspected areas.,,.
should be leak tested If the hose leaks it must be replaced prior to operation Only use the., .
replacement hose assembly specified by manufacturer The burner must be replaced prior to the.
appliance being put into operations if it is evident that the burner is damaged The replacement burner.
should be specified by manufacturer.
Lighting:
1 Turn the control knob to the “OFF”position Figure A)().
2 Fully open LP cylinder valve).
Note For initial start or after any cylinder change hold Control Knob IN for:,
2 minutes to purge air from gas lines before proceeding.
3 Push in gas control knob and turn counterclockwise to “IGNITE”)
() . ,Figure B to light the fire pit If needed keep depressing and turning control knob
counterclockwise until the fire pit lights you should hear a clicking sound().
4 After fire pit lights release control knob Push in and turn the control knob counterclockwise to), .
the “HIGH” Position then release control knob If you want a lower temperature push in the control
knob and turn counterclockwise to the “LOW” Figure C().Position
Note: If burner fails to remain lit, all valves should be closed and a waiting period of at least 5
minutes should pass before attempting to light.
Caution:
Do not attempt to operate until you have read and understand all General Safety Information
in this manual and all assembly is complete and leak checks have been performed.
Figure A
O
F
F
P
u
s
h
t
o
t
u
H
r
G
n
I
H
LOW
E
T
I
N
G
I
Figure B
O
F
F
P
u
s
h
t
o
t
u
H
r
G
n
I
H
LOW
E
T
I
N
G
I
Figure C
O
F
F
P
u
s
h
t
o
t
u
H
r
G
n
I
H
LOW
E
T
I
N
G
I