Instructions / Assembly

OPERATION INSTRUCTIONS

Shut Down:

1 To extinguish burner depress control knob and continue to turn it clockwise to OFF. .

2 Turn cylinder valve clockwise to OFF and disconnect regulator when heater is not in use. .

Re lighting-:

1 Turn control knob to OFF..

2 Repeat the “Lighting” steps on prior page..

WARNING

FOR YOUR SAFETY

Be careful when attempting to manually ignite this

fire pit Holding in the control know for more than 10.

seconds before igniting the gas will cause a ball of

flame upon ignition.

WARNING

FOR YOUR SAFETY

Fire pit will be hot after use Handle with extreme care..

CARE AND MAINTENANCE

WARNING

FOR YOUR SAFETY:

Do NOT touch or move fire pit for at least 45 minutes

minutes after use.

Fire Pit is hot to the touch.

Allow Fire Pit to cool before touching.

To enjoy years of outstanding performance from your fire pit make sure you perform the following,

maintenance activities on a regular basis:

Keep exterior surfaces clean.

1 Use warm soapy water for cleaning Never use flammable or corrosive cleaning agents.. .

2 While cleaning your unit be sure to keep the area around the burner dry at all times Do not submerge., .

the control valve assembly If the gas control is submerged in water do NOT use it It must be replaced.,..

a Keep the appliance area clear and free from combustible materials gasoline and other.,

flammable vapors and liquids.

b Do not obstruct the flow of combustion and ventilation air..

c Keep the ventilation opening s of the cylinder enclosure free and clear from debris.() .

3 Air flow must be unobstructed Keep controls burner and circulating air passageways clean Signs..,, .

of possible blockage include:

When fire pit is ON:

Burner will display tongues of blue and

yellow flame

These flames should not produce

thick

black smoke

which would indicate an obstruction of airflow through the burner

The

flame

should

blue with straight yellow tops.