Instructions / Assembly
15
CARE AND MAINTENANCE
Gas odor with extreme yellow tipping of flame.
Fire pit does NOT reach the desired temperature.
Fire pit glow is excessively uneven.
Fire pit makes popping noises.
Spiders and insects can nest in burner or orifices. This dangerous condition can damage fire pit and
render it unsafe for use Clean burner holes by using a heavy duty pipe cleaner Compressed air may.-.
help clear away smaller particles.
Carbon deposits may create a fire hazard. Clean dome and burner screen with warm soapy water if
any carbon deposits develop.
Note: In a salt air environment such as near an ocean corrosion occurs more quickly than normal- ( ), .
Frequently check for corroded areas and repair them promptly.
TIP:
Use high-quality automobile wax to help maintain the appearance of
your fire pit. Apply to exterior surfaces from the pole down. Do not
apply to emitter screen or domes.
Make sure to properly locate the gas hose by keeping it out of pathways where people may
trip over it or in an area where the hose may be subject to accidental damage Always.
inspect the hose for evidence of excessive abrasion cuts or wear prior to use and make,,
sure to leak test.
Storage
Between uses:
Turn Control Knob OFF.
Disconnect LP source.
Store fire pit in an area sheltered from direct contact with inclement weather (such as rain,
sleet hail snow dust and debris,, , ).
If desired, cover fire pit to protect exterior surfaces and to help prevent build-up in air passages.
Note: Wait until fire pit is cool before covering.
During periods of extended inactivity or when transporting:
Turn Control Knob OFF.
Disconnect LP source and move to a secure, well-ventilated location outdoors.
Store fire pit in an area sheltered from direct contact with inclement weather (such as rain,
sleet hail snow dust and debris,, , ).
If desired, cover fire pit to protect exterior surfaces and to help prevent build-up in air passages.
Never leave LP cylinder exposed to direct sunlight or excessive heat.
Note:.Wait until fire pit is cool before covering
Service
Only a qualified service person should repair gas passages and associated components.
Caution:.Always allow fire pit to cool before attempting service