Warranty

ASSEMBLY

*Optional Sandbox: For models that come with a sandbox, the

sandbox will be pre-assembled to the base. To ll the sandbox,

remove the 4 Large Screws and Large Nuts that secure the

base to the sandbox. Pull open the plastic cap on top of the

sandbox and ll the sandbox with water or sand. Replace the

plastic cap. Slide Base back over the sandbox and align the

holes in the base with the holes in the sandbox. Insert Large

Screws through the holes in the base and secure by tightening

Large Nuts on ends of the bolts. You may nd it easier to ll the

sandbox prior to attaching wheels.

Attach Wheel Assembly

to Base

. Align holes in

Wheel Assembly with corresponding holes in Base,

and insert 2 Small Bolts through the holes and nger tighten.

Be sure that the Wheel Assembly is parallel to the Base

and tighten with the Wrench.

Hardware Used: 2x Small Bolts

Attach the Post Supports

to the Base

. Align the holes

in the bottom of each Post Support with the hole on the

Base. Insert 1 Small Bolt through the hole in the support and

into the Base and hand tighten. Repeat with the other 2 Post

Supports and then tighten all bolts with the Wrench.

Hardware Used: 3x Small Bolts

Plastic Cap

Sandbox

Base

PREPARATION

Before beginning assembly of this appliance, make sure all parts are present. Compare all parts with package contents list

and hardware contents as listed on page 4 of this manual. If any part is missing or damaged, do not attempt to assemble

this product. Contact customer service for replacement parts.

ESTIMATED ASSEMBLY TIME: 60 minutes

Tools Required for Assembly (NOT included):

• Phillips screwdriver w/medium blade • Leak test solution (see page 10)