Use and Care Manual
31” Round PNP Fire Pit Insert
Assembly Instrucons
Step One:
Take 1 panel and 1 connector bracket. Hold the bracket along out-
side edge of panel. Use two bolts and nuts to aach bracket to
panel. Make sure the at side of the bolt is on the inside of pit.
Wait to ghten hardware unl all panels are assembled.
Step Two:
Hook next panel to other side of connector bracket. Add all panels
and connectors. Once, all panels are aached, use wrench to ghten
bolts.
Parts Included:
(4) panels, (4) connector brackets, (4) PNP brackets for accesso-
ries, (16) bolts, (16) nuts with locking washer
Step Three:
Aach accessory brackets on the outside in the middle of each panel
with the round hole facing upwards. Use to bolts and nuts to aach
each bracket, ghten with wrench.