User's Manual

Energy Saving Lamp
Introduction
·Conserves natural resources by saving 80% less electricity than incandescent bulbs.
·About 10 times lamp life than a standard incandescent bulb.
Notice For Use
·Never use with the following fixtures:
dimming circuit
emergency lighting fixtures
electronic timer fixtures
direct current fixtures
·Use only at the rated voltage and frequency circuit. The power voltage fluctuation must be
within a± 10% voltage rang.
·Use indoor only. Never install in a position where water may drop on the lamp or where the
atmosphere is humid.
·Not recommended for use at high or low ambient temperature 【above 40℃ or below 0℃】
·Do not use in fixture that would enclose lamp. If lamp enclosed, the lamp’s life would be
shorten.
·Always turn off the switch when replacing or cleaning the lamp. Remove and install by
grasping only the plastic portion of the lamp.
·Added weight may cause instability of free-standing portable lamps in which the distance
from the bottom of the base to top of the lamp hold dose not exceed 3 times minimum vase
width. Use only with portable lamps which are provided with lamp shade.
● This product could produce interference when used near 0.7V, radio, wireless remote control
or maritime safety communication equipment, or other critical navigation of communication
equipment operating between 0.45---30 MHZ. If interference would occur, move the lamp
away from the appliance a distance of three feet or more, Or plug the lamp or the appliance
into a different outlet.
·This product complies with Part 18 of the FCC Rules but may cause interference to
radios, television , wireless telephones, and remote controls. If interference occurs, move
product away from the device or plug either into a different outlet, or move the lamp out of
the sight with the remote control receiver.