Installation Sheet

Zone divider

Groove

Front

INSTALLATION (cont.)

4. Turn all burner control knobs to the OFF position.

Turn the gas supply on. Then carefully check all gas

connections for leaks with a brush and half-soap/

half-water solution before lighting. NEVER USE A

MATCH OR OPEN FLAME TO TEST FOR LEAKS.

5. Close the shut-off valve, then slide the grill into

place. Do not to pinch, kink, or damage the gas

connector line.

6. Rotate the adjustable support screws to the left to

raise and to the right to lower the respective side

of the appliance grill. Use a

/16" open-end wrench

as needed. See Fig. 22-1.

Important: Do not extend the support screws so

far that any part of the hanger is raised

off the counter top.

INSTALL ZONE DIVIDERS

Place the zone dividers as shown (Fig. 22-2) into the

grooves in the inner ﬁ rewall of the grill to allow for

maximum heat control and thermometer accuracy in

each zone. Remove and store during rotisserie use.

INSTALL THE FLAVOR GRIDS

Place the ﬂ avor grids directly onto the studs on the

burners. See Fig. 22-3. The slightly larger grids are

designed to be placed over the outside burners, and

the slightly smaller grid(s) over the inner burner(s).

The ﬂ avor grids allow heat from the burners to be evenly

distributed throughout the cooking area.

Fig. 22-3 Install ﬂ avor grids

Place onto studs

Fig. 22-2 Install zone dividers

Adjustable

support

screw

Bottom of

face

Bottom

of cut-out

opening

Fig. 22-1 Adjust support screws