Installation Sheet

SERVICING AND CLEANING (Cont.)

POWER SUPPLY FUSE REPLACEMENT

1. Locate the power supply box inside of the island

enclosure (reference the PARTS LIST).

2. Using a phillips screwdriver, remove the 4 large

screws found on the cover of the power supply

box (see Fig. 38-1).

3. Disconnect the power supply cord. Then

disconnect the wire harness and ground wire

(see Fig. 38-2). Completely remove the box from

the enclosure for ease of fuse replacement.

4. Remove the 4 small screws found on the cover

of the power supply box (see Fig. 38-3).

Note: The 2 center screws do not need to be

removed.

5. Carefully open the box by pulling its cover away.

You may need to feed the wire harness into the

box to provide enough slack to open on the

other end. Then “push in and twist” the fuse

holder (red wire), exposing the fuse. See Fig.

38-4.

6. Replace the fuse accordingly (3AG 1.25 AMP).

Disconnect

here

Fig. 38-1 Remove 4 large screws

Fig. 38-2 Disconnect wire harness and

groundwire (and power cord)

Fig. 38-3 Remove 4 small screws

Fig. 38-4 Carefully open box and replace

fuse (red wire)