Installation Sheet

40
SERVICING AND CLEANING (Cont.)
3. Unfasten the two backburner nuts (found on the left
side of the backburner) using a
1
/
4
" nut driver and
set them aside. See Fig. 40-2.
4. Remove the backburner by lifting the left side outward
and to the left. See Fig. 40-3.
5. Use a
3
/
8
" hex nut driver to remove the exposed orifi ce
(Fig. 40-4). Check orifi ce. If needed, replace it with
the correct orifi ce for the new gas.
6. Replace the backburner assembly and fasten the two
nuts using a
1
/
4
" nut driver.
7. Replace the backburner cover and warming rack.
Fig. 40-1
Fig. 40-3
Fig. 40-4
Fig. 40-2
Orifi ce
Convert/Check Infrared Burner Orifice (if
equipped)
1. Remove the cooking grid from above the burner.
2. Unscrew both lighting tube hex head screws with a
3
/
8
" hex nut driver.
3. Remove the infrared burner by lifting the back of the
burner up so that both tabs are freed from their slots,
then lift the burner toward the back of the fi re box
and upward. Set the burner aside.
4. Use a
3
/
8
" hex nut driver to remove the exposed
orifi ce. Check orifi ce. If needed, replace it with the
correct orifi ce for the new gas.
5. Replace the infrared burner by fi rst sliding it over the
orifi ce, then lowering the two tabs under the back of
the burner into the slots in the back burner rest.
6. Reattach the lighting tube and replace the grid so
that the cut-out section is in front.