Installation Sheet

24
POWER SUPPLY HOOKUP
CAUTION: IMPROPERLY CONNECTED WIRES WILL
CAUSE DAMAGE TO THE GRILL AND MAY
RESULT IN PROPERTY DAMAGE AND/OR
PERSONAL INJURY.
This grill includes a power supply box. When installing the
power supply box:
• It MUST be located at least 12 inches below the bottom
of the grill (see Fig. 24-3).
• The wire extension that exits from the control panel MUST
be routed directly downward. This will prevent overheating.
DO NOT route the wire extension below the grill (see Fig.
24-3).
Note: For enclosures with a solid area beneath the grill,
a cutout must me made near the wire extension to
allow for the above requirement. If an insulating liner
is installed, route the wire down through the nearest
hole possible.
• DO NOT block the vent holes found on the box.
Fasten the power supply box to the inside of the enclosure
using appropriate hardware for your enclosure.
The electrical connections from the power supply box to the
grill electrical systems come pre-connected.
WARNING: Electrical Grounding Instructions - This
appliance is equipped with a three-pronged
(grounding) plug for your protection against
shock hazard and should be plugged
directly into a properly grounded three-
prong receptacle. Do not cut or remove the
grounding prong from this plug.
CONNECT THE POWER SUPPLY TO LINE POWER
Connect the cord coming from the unit's power supply to a
120VAC (15 AMP minimum) GFCI GROUNDED 3-wire
receptacle. The GFCI receptacle must be a WEATHER-
PROOF IN-USE COVERED RECEPTACLE.
Grounded
plug
G
rou
n
p
lu
Fig. 24-3 Power supply clearance
Fig. 24-2 Wire connections
Fig. 24-1 Power supply detail
12"
Min.
Route wires
directly downward
(to prevent
overheating)
Required 120VAC (15 AMP
minimum) GFCI GROUNDED
3-wire receptacle (not included)
ELECTRICAL INSTALLATION