Fire Feature Owner's Manual A WARNING: FOR OUTDOOR USE ONLY A ATTENTION INSTALLER: PLEASE LEAVE THESE INSTRUCTIONS WITH THE CONSUMER. CONSUMER: PLEASE READ & RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE AND BEFORE INSTALLING OR OPERATING. A WARNING + Improper installation, adjustment, alteration, service, or maintenance can cause injury, death, or property damage.
GENERAL SAFETY & INSTALLATION WARNINGS Safe operation of this fire feature depends upon its proper installation. A qualified professional installer and service technician must perform adjustments and service of the burner. Proper location and proper use is essential to insure safe and continued trouble-free operation. Any non-approved alterations made to the fire feature will void the product's warranty.
An BEWARE OF SPIDERS +ยป CAUTION: BURNER TUBES MUST BE INSPECTED AND CLEANED BEFORE EACH USE. + Spiders and small insects occasionally spin webs or make nests in the burner tubes. These webs can lead to a gas flow obstruction, which could result in a fire in and around the burner tubes. + Frequent inspection and cleaning of the burner tubes is necessary. A WARNING # This fire feature should be inspected before use and at least annually by a qualified service person.
FIRE FEATURE INSTRUCTIONS A WARNING: FOR OUTDOOR USE ONLY If designing and building your own fire feature, please read and follow the instructions below. In addition to the information below, you must check your local codes and consult the local authority having jurisdiction. Do not operate in a building, garage or any other enclosed areas. This could result in carbon monoxide buildup which could result in injury or death. Ensure your burner is positioned safely away from anything that can catch fire.
Do not store any LP cylinder or tank not connected for use with the burner, in the area of this burner, inside or around the fire pit, or any other appliance. Never store an LP cylinder or tank indoors, or within the reach of children. Never test the burner for gas leaks using a lighted match or any other open flame; see section on Leak Testing. The use of accessories, regulators, or components not recommended by the burner manufacturer may cause injuries and will void warranty.
GAS SAFETY AND INSTALLATION WARNINGS + All gas connections should be made by a professional qualified technician and in accordance with local codes and ordinances. The installation must conform with local codes. Do not twist the gas supply hose. Before each use, visually inspect the gas supply hose for cracks, cuts or excessive wear. Replace the hose if necessary. Check for gas leaks before each use. + Gas Specifications: Be sure the gas supplied to the burner conforms with the burner you purchased.
CHECKING FOR GAS LEAKS Perform a leak test before each use whether the gas supply has been disconnected or not. In addition, whenever the gas is connected to the regulator or whenever any part of the gas system is disconnected or replaced, perform a leak test. As a safety precaution, remember to always leak test your burner outdoors in a well-ventilated area. Never smoke or permit sources of ignition in the area while doing a leak test. Do not use a flame, such as a lighted match to test for leaks.
FIRE FEATURE OPERATION Gas pressure and type should be checked prior to use and installation. Natural Gas: Supply pressure: Minimum 3.5% W.C_; Maximum 5.0" W.C. Before use, test all gas connections for leaks. Do not use fire feature if there is any evidence of leaking gas. If leaking gas is suspected, turn off main gas supply and have repaired immediately by a qualified technician. Wind and gusty conditions will affect the flame in an unpredictable manner.
FIRE FEATURE START-UP Unpacking the Unit: A final inspection of your product occurs at the factory to ensure a quality product is packaged. Please re-check for possible shipping damage immediately after unpacking your burner. If the burner is found to have some damage, contact your dealer immediately as often the shipping carrier will have a time frame to report damage. Please also save the packaging material the product came with as that is at times inspected by the shipping carrier.
LIMITED WARRANTY Firebrand Stainless Steel burners and pans are warrantied against manufacturing defects under normal use and service for a period of 10 years. Installation, repair and maintenance work should be performed by an authorized service technician. Work by unqualified persons could be dangerous and will void the warranty. All Natural and LP Gas appliances must have a qualified installer complete the installation for the warranty to be in effect.
Fire Feature Ventilation WARNING Failure to adequately vent your fire feature could result in an explosion or fire. When building or installing a fire feature, it is necessary to provide adequate ventilation. This is necessary for not only proper combustion, but also to prevent a buildup of gas. Vents must be placed on opposing sides to allow for cross ventilation. Each vent must have at least 18 square inches of ventilation per side. This allows for heat and/or residual fuel to escape.