- Fireplace Xtrordinair Built-In Direct Vent Fireplace Installation Manual

Finalizing the Installation (for qualified installers only) 47

Fireback and Grate Installation

WARNING: Firebacks are required for this fireplace and must be installed prior to operation.

1 Remove the glass frame.

3 Remove the exhaust restrictor (see page 23). Make sure to return the restrictor to the correct position after

the firebacks are in place.

4 Install the firebacks and grate following the directions below.

Place the rear fireback in place. The side

fireback holds the rear fireback in place -

hold the rear fireback while installing the

side fireback.

Remove the screws and

clips on both sides.

Place the side firebacks

in place. Secure using

the screws and clips

removed in step “a”.

Place the floor

firebacks in place.

5/16" Nutdriver

Place the grate in place. Take care to

prevent it from damaging the ceramic

firebacks.