Indoor Fireplace User Manual

ManualsBrandsFireplaceXtrordinair ManualsIndoor Fireplace95800624

864TRV Rectangular Face

Black 95800623

Nickel 95800624

Page 1 of 4 17601486 - 8/30/10 © Travis Industries, Inc.

Compatibility:

• 864TRV Fireplace

• 864ST Fireplace

• 864HO Fireplace

Packing List:

• Face • (12) 8-32 Nuts

• Face Mounting Brackets (upper and lower sets) • (2) 10-24 1-1/2" Screws

• (2) Face Brackets (w screws)

Installation Details

SIDE OF FIREPLACE

1”

5/16” TO 1”

NOTE:

This face has an adjustable bracket that allows for

different facing depths to be tucked under the face.

40-7/8”

35-5/8”

Special Instructions for 864HO Fireplaces

This face requires the outer grill deflectors to be removed. See the instructions below.

Remove the outer deflector on both sides

(use needle-nose pliers if necessary).

These tabs bend down

to allow for removal.

Re-attach the deflectors to the top louver

for future use if using a different face or

grill. Bend the tabs as shown, making

sure the deflectors are secure and flat.

Summary of content (4 pages)

PAGE 1
864TRV Rectangular Face Black 95800623 Nickel 95800624 Compatibility: • 864TRV Fireplace • 864ST Fireplace • 864HO Fireplace Packing List: • Face • Face Mounting Brackets (upper and lower sets) • (2) Face Brackets (w screws) • (12) 8-32 Nuts • (2) 10-24 1-1/2" Screws Installation Details 40-7/8” SIDE OF FIREPLACE 35-5/8” 1” 5/16” TO 1” NOTE: This face has an adjustable bracket that allows for different facing depths to be tucked under the face.
PAGE 2
864TRV Rectangular Face Black 95800623 Nickel 95800624 Installation 1 Attach the brackets to the fireplace following the directions below. Remove and discard the nuts and bushings above and below the firebox. Discard the stock bushings and nuts. Upper Bracket Place the upper and lower brackets in place and secure using the nuts included with this kit. Discard the stock bushings and nuts. Lower Bracket Repeat these steps for the opposite side.
PAGE 3
864TRV Rectangular Face Black 95800623 Nickel 95800624 2 The facing and hearth (if applicable) must be installed prior to attaching the face. See the installation manual for complete details. Raised Fireplaces Note how the tile is 1” (maximum) above the base of the fireplace. Floor-Level Fireplaces Maximum 1`” Hearth Page 3 of 4 17601486 - 8/30/10 © Travis Industries, Inc.
PAGE 4
864TRV Rectangular Face Black 95800623 Nickel 95800624 3 Install the face following the directions below. a The face is secured to the fireplace Attach the upper brackets to the face with the included nuts. Slide the face into place. The with four screws. Two of the screws b are fastened to the upper brackets with press nuts. The lower screws tabs on the upper brackets insert into the slots on the fireplace brackets, holding the face in place are included with the face.