User's Manual

8 HotPort 3200 Series User Guide

Restoring Default Settings

You can restore your HotPort node to its factory default settings using the provided HotPort 3203 reset application. This application is

provided on the CD-ROM disc included in the HotPort package.

Note: To reset a HotPort to its factory defaults, you must run the reset application within 3 minutes after the HotPort boots up.

1. Install the reset application on a workstation. If running Windows, install the Windows application (3200factoryreset.exe);

if running Linux, install the Linux version of the application (3200factoryreset.bin).

2. Connect the workstation’s network adapter directly to an available Ethernet port on the HotPort using an Ethernet cable. Make

sure the HotPort is powered.

3. Start up and run the factory reset application.

HotPort Factory Default Settings

AES encryption: Disabled

WEP encryption: Disabled

Mesh IP address: 192.168.224.150

Ethernet ports: All ports enabled

HotView username: admin

HotView password: ﬁretide

Radio Power = 75% of approved maximum power

ESSID = HOTPORT_MESH

Default radio channel depends on model; refer to the table on page 2.

After a factory reset, you will need to specify the country code for Model 3203 HotPorts. All other mdoels are US-only. Refer to the

HotView User Guide for information on using the HotView software to conﬁgure your HotPort nodes.