User's Manual

ManualsBrandsFiretide ManualsElectronicsHotPort 3600-2400

12 HotPort 3200 Series User Guide

Appendix D

Regulatory Notices

FCC Class B Notice

This device complies with Part 15 of the FCC Rules. Operation

is subject to the following two conditions:

1. This device may not cause harmful interference.

2. This device must accept any interference received, includ-

ing interference that may cause undesired operation.

FCC Part 15 Note

This equipment has been tested and found to comply with

the limits for a Class B digital device, pursuant to Part 15 of

the FCC Rules. These limits are designed to provide reason-

able protection against harmful interference in a residential

installation. This equipment generates, uses and can radi-

ate radio frequency energy and, if not installed and used

in accordance with the instructions, may cause harmful in-

terference to radio communications. However, there is no

guarantee that interference will not occur in a particular in-

stallation. If this equipment does cause harmful interference

to radio or television reception, which can be determined by

turning the equipment off and on, the user is encouraged to

try to correct the interference by one or more of the follow-

ing measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and re-

ceiver.

• Connect the equipment into an outlet on a circuit dif-

ferent from that to which the receiver is connected.

• Consult the dealer or an experienced radio/television

technician for help.

FCC Part 90 Note

This equipment has been tested pursuant to FCC Part 90, DSRC-C mask

certiﬁcation, and is approved for use in the US on Public Safety bands by

licensed Public Safety agencies.

Modiﬁcations

Any modiﬁcations made to this device that are not approved by

Firetide, Inc. may void the authority granted to the user by the

FCC to operate this equipment.

FCC Radiation Exposure Statement

The antenna used for this transmitter must be installed to pro-

vide a separation distance of at least 35 cm from all persons and

must not be co-located or operating in conjunction with any

other antenna or transmitter. OEM Integrators, end-users and in-

stallers must be provided with antenna installation instructions

and transmitter operating conditions for satisfying RF exposure

compliance.

Public Safety Band

Pursuant to Part 90.1215, use of antennas with gain greater than

9 dBi and up to 26 dBi in the 4.940 – 4.990 GHz Public Safety band

is permissible without reduction of TX output power. The antenna

shall have a directional gain pattern in order to meet the require-

ment of point to point and point to multi-point operation.