User's Manual

HotPoint Wireless Access Point 7
Next, attach the plate, using two more nuts, as shown in Figure 6. Adjust
the spacer nuts to insure that the U-bolts do not protrude out of the fold in
the plate. The exact adjustment will depend on pole diameter.
Figure 6. Mounting Plate
When the plate is mounted and aligned, tighten all the nuts with a 7/16-
inch wrench. Then slide the HotPoint onto and downward slightly, so that
its tabs on its backing plate (Figure 7) engage the mounting plate, as shown
in Figure 8. Tighten the four knurled nuts on the sides.
The supplied antennas can be used for initial deployment, but should be
replaced after initial testing with outdoor-rated units of suitable gain and
pattern.
Figure 7. AP Bracket Mounting Tabs
Figure 8. AP Mount - Finished