User's Manual

12 Wireless Access Point User Guide
AP Node Commands
These commands are accessed by right-clicking the AP icon. Begin by as-
signing an IP address to each node, and logging in to the node. You must
then set the Country Code. Finally, you should rename each node.
Command Function
Rename AP Assigns the management screen name to the physical
node. Note: this is NOT the SSID of the node; that is
specified under the VAP Group Configuration command.
IP Settings (includes
Management VLAN)
Assigns the IP address that will be used by the AP for
management access. This command also allows you to
assign a management VLAN, if desired.
Release Lock Releases management control lock on APs.
Login
The default user ID and password is admin and firetide.
Statistics Shows performance for a given VAP.
AP Configuration
(Radio)
Allows you to specify the radio parameters, firewall
configuration, and VPN.
VAP Configuration Allows you to define DHCP service for the VAP.
VAP Group
Configuration
Allows you to define radio and security options for a
group of Virtual Access Points.
Country Code Set once at initial startup.
Reboot, Reset Allows you to reboot or reset to factory defaults.
Import, Apply Allows you to save and restore node settings.
Refresh Forces HotView to re-acquire the status of the AP.
Delete HotPoint Removes ‘stale’ HotPoint icons from HotView.
Summary Gives a summary of HotPoint node information.